Abstract:<div><div>Electric vehicles (EV’s) present new challenges to achieving the required noise, vibration & harshness performance (NVH) compared with conventional vehicles. Specifically, high-frequency noise and unexpected noise phenomenon, previously masked by the internal combustion engine can cause annoyance in an EV. Electric motor (E-motor) whine noise caused by electromagnetic excitation during E-motor operation is caused by torque ripple and radial excitation. Under high speed and high load operating conditions, the overall sound level may be low, however high frequency whine noise can impair the vehicle level NVH performance. An example of a previously masked unexpected noise phenomenon is a droning noise that can be caused by manufacturing quality variation of the spline coupling between the rotor shaft of the E-motor and the input shaft of the reducer. It is dominated by multiple higher orders of the E-motor rotation frequency.</div><div>In this study, the high speed and high load condition whine noise problem was reproduced through electromagnetic and structural analysis. The countermeasures (E-motor geometry refinements to reduce the excitations and mechanical system transfer path modifications to reduce the vibration response) were defined and the effects investigated. Mechanical system modification to improve NVH performance without increasing the mass is challenging. However, E-motor air-gap geometry optimization, such as slot opening modulation and rotor notch modifications achieved significant noise reduction without critical trade-off of other performance.</div><div>This paper also describes the basic improvement plan proposed through the simulation of the droning noise behavior. The main two manufacturing errors (pitch error in the spline coupling and the alignment error between the rotor and the gearbox shafts) that are responsible for the unexpected droning noise were identified. Using simulation it was shown that the droning noise can be reduced through improved quality control and tolerance design optimization of factors such as axis self-alignment and spline gear tooth quality.</div></div>

Vibration control of commercial vehicle drive axles based on modification of helical gears

Application of Acoustic Transfer Vector Algorithm on Acoustic Radiation for Drive Axle of Automobile

Research on noise reduction of drive axle hypoid gear based on tooth surface mismatch modification

Influence of Different Modified Gears on the Vibration and Noise of Electric Vehicle Reducer

A study on axle gear whine noise reduction with deflection test

Dynamic Modelling and Parametric Optimisation of Vibro-Acoustic Responses for Power-Split Hybrid Transmission

Moan Noise Diagnosis and Research of Certain E-axle BUS

Dynamic modeling and analysis for a drive axle gear transmission system

Optimization design for dynamic characteristics of face gear drive with surface-active modification

Optimization of the Housing Shape Design for Radiated Noise Reduction of an Agricultural Electric Vehicle Gearbox

Investigation of Effect of the Tooth Profile Modification on the Engagement Characteristics of the Gear Pair

Impact of Gear Modification on Gear Dynamic Characteristics

Design of Multi-Stage Gear Modification for New Energy Vehicle Based on Optimized BP Neural Network

Robust Optimisation of Dynamic and NVH Characteristics for Compound Power-Split Hybrid Transmission

A Novel Method for Vibration Signal Transmission and Attenuation Analysis in Complex Planetary Gearboxes

Robust Development of Electric Powertrain NVH for Compact Electric SUV

Investigation of the lubrication system in a vehicle axle: Optimization and experimental validation

Experimental and Numerical Analysis for the Transmission Gear Rattle in a Power-Split Hybrid Electric Vehicle

Tooth Profile Modification of Helical Gears and Experimental Study Based on Finite Element Contact Analysis

Research on modification and noise reduction optimization of Electric Multiple Units traction gear under multiple working conditions

Optimization of energy efficiency and NVH behaviour of a helical gear unit