Abstract:Coprecipitation is the most commonly used method to synthesize iron oxide nanoparticles (IONPs) due to its low cost and environmentally friendly synthesis process. Recently, several studies have proposed that the coprecipitation formation of IONPs is through the aggregation of initially formed primary particles. However, there are still lack of systematic researches about the room temperature coprecipitation formation process of IONPs under quick mixing mode. Here, a gas/liquid mixed phase fluidic reactor was specially designed, and the influences of reaction time, reaction pH and valence of iron ions on the coprecipitation formation of IONPs in quick mixing mode were studied. The NH3 gas was used as the alkaline reactant. At pH above 10.0, the iron ions promptly hydrolyzed and precipitated to form primary nanoparticles, and then the primary nanoparticles accreted to form Fe3O4 nanoparticles in 2 min 30 s. As the reaction pH increased from 2.5 to 9.5, extremely small particles gradually aggregated to form Fe3O4 nanoparticles. Large Fe3O4 nanoparticles with a mean diameter of ~ 8.1 nm were completely formed at pH 9.5. And a small amount of poorly crystalline intermediate phases including akageneite, ferrihydrite and goethite were observed during this process. When Fe2+ ions were absent during the reaction process, the final products had poor crystallinity and weak magnetic properties. While if only Fe2+ ions were used in the precursor, the sheet-like green rusts generated firstly, and Fe3O4 nanoparticles would gradually form on the surface of green rusts with the partial oxidation of Fe2+ ions. The results of regulating the reaction conditions especially reaction pH indicate that this reaction design can effectively reduce the formation of intermediate crystal phases.

Preparation of Superfine Transparent Iron Oxide Yellow Pigment By Homogeneous Precipitation Method

Influence of Different Preparation Methods on Crystallisation and Morphology of Fe2o3 Nanoparticles

Preparation of nano Fe3O4 pigment using CO32−/HCO3− as precipitant and DFT study on the formation process of its intermediate product FeOOH

Influence of Iron Dopant on Crystallization and Photo-Induced Hydrophilicity of TiO2 Thin Films

Process Optimization and Preparation of Ferric Oxide Nanoparticles by Homogeneous Precipitation Method

Preparation of Nanosized Iron(Ⅱ) Sulfide by Homogeneous Precipitation Method

Preparation of Gamma Iron Oxide Particulate by a Low Temperature Flux Method

Facile Methods to Synthesize Nanaosized Iron Oxide Colloidal Dispersion and Its Characterization

Study on the Preparation and Properties of Colored Iron Oxide Thin Films

Preparation of nano-sized iron oxide from steel pickling liquors

An Environmentally Friendly Method for Producing α-Fe2O3 Pigment from Low-Grade Hematite Residue

Preparation of FePO4 Nano-Particles by Coupling Fast Precipitation in Membrane Dispersion Microcontactor and Hydrothermal Treatment

In Situ Precipitation: a Novel Approach for Preparation of Iron-Oxide Magnetoliposomes.

The coprecipitation formation study of iron oxide nanoparticles with the assist of a gas/liquid mixed phase fluidic reactor

Ultrasonic-assisted Preparation of Monodisperse Iron Oxide Nanoparticles

Study on Preparation of Yttrium Oxide with Large Particle Sizes and Spherical Shapes by Precipitation with Ammonium Bicarbonate

Synthesis of Nearly Monodisperse Iron Oxide and Oxyhydroxide Nanocrystals

Synthesis of Uniform Ferric Oxide Particles from Deionized Colloids

Dispersion and Physico-Chemical Characterization of Iron Oxide on Various Supports

Preparation of Nanometer Γ-Fe2o3 by Electrochemical Oxidation in Non-Aqueous Medium

Preparation, Chromatic Properties Analysis and Proportioning Optimization of Co-Cr-Fe-Based Black Pigment