Abstract:An Experimental investigation was conducted to compare the evaporation characteristics of R410A inside three newly developed horizontal enhanced heat transfer (EHT) tubes with the same OD12.70mm and ID11.50mm, and the result of them are compared with that of a plain tube. The inner enhanced surface of 1EHT tube consists of dimples/protrusions and petal arrays, while that of 2EHT-1 tube and 2EHT-2 tube is composed by longitudinal grooves and dimples of different depths. The mass velocities are in the range of 70kg/m2s-200kg/m2 s with a nominal saturation temperature fixed at 279K and the vapor quality in the test section varies from 0.2∼0.9. As the mass flux increases, both the heat transfer coefficient and pressure penalty increase accordingly. The heat transfer coefficient of EHT tubes can achieve 1.14–1.53 times higher than that of the smooth tube while the pressure gradients is 1.43–1.83 times larger than that of smooth tubes. Besides, the enhancement ratios of all the enhanced surface tubes are larger than their respective surface area ratio, and the enhancement ratio comparisons of heat transfer coefficient are made to obtain the enhancing mechanism. The results show that the EHT tubes appear higher performance at low mass fluxes. In all, the EHT1 tube has the best heat transfer performance at low mass velocity, which can be attributed to its special enhanced inner surface, resulting in the increase of nucleation sites, flow separation and turbulent fluctuations. The other two 2EHT tubes can enhance the evaporation greatly with small respective surface ratios as well as relatively little pressure drop penalty, and them shows outstanding performance especially at high mass velocity.

Enhanced pool boiling of propane on horizontal U-shaped tubes in a large-scale confined space

Experimental study on the pool boiling heat transfer of R134a outside various enhanced tubes

Heat transfer enhancement of helical tubes during pool boiling

Pool boiling heat transfer of ammonia outside enhanced tubes with various fin structures

An Experimental Study on Flow Boiling Heat Transfer Outside Horizontal Enhanced Tubes

Numerical simulation on flow boiling heat transfer of CO2/propane mixture in tubes with/without micro-fins

Investigation of Flow Boiling Heat Transfer Characteristics of CO2in Horizontal Mini-Tube

Nucleate pool boiling and filmwise condensation heat transfer of R134a on the same horizontal tubes

Enhancement of Pool Boiling Heat Transfer on Porous Surface Tube

Flow Boiling in Inner Annulus of Horizontal Enhanced Tubes

Flow Boiling Heat Transfer Characteristics in Horizontal, Three-Dimensional Enhanced Tubes

Experimental study on the flow boiling heat transfer in horizontal tubes with composite structure

EXPERIMENTAL STUDY ON POOL BOILING HEAT TRANSFER ENHANCEMENT WITH MICRO/NANOSTRUCTURED SURFACES

Pool Boiling Heat Transfer of Water in a Horizontal Tube Bundle

Comparison of flow boiling heat transfer characteristics inside different enhanced heat transfer tubes

Pool Boiling Heat Transfer of R134a Outside Reentrant Cavity Tubes at Higher Heat Flux

Entropy generation and thermodynamic analysis of pool boiling heat transfer on doubly enhanced tubes

Effect of Wettability on Nucleate Pool Boiling Heat Transfer of a Low Surface Tension Fluid Outside Horizontal Finned Tubes

Pool boiling heat transfer outside horizontal tubes at higher heat flux

Investigation on Heat Transfer of In-Tube Supercritical Water Cooling Accompanying Out-Tube Pool Boiling

Experimental Investigation of Flow Boiling Inside Three Three-Dimensional Surface Enhanced Heat Transfer Tubes