Abstract:Alkalinity generation and toxic trace metal (such as vanadium) leaching from basic oxygen furnace (BOF) steel slag particles must be properly understood and managed by pre-conditioning if beneficial reuse of slag is to be maximised. Water leaching under aerated conditions was investigated using fresh BOF slag at three different particle sizes (0.5–1.0, 2–5 and 10 × 10 × 20 mm blocks) and a 6-month pre-weathered block. There were several distinct leaching stages observed over time associated with different phases controlling the solution chemistry: (1) free-lime (CaO) dissolution (days 0–2); (2) dicalcium silicate (Ca2SiO4) dissolution (days 2–14) and (3) Ca–Si–H and CaCO3 formation and subsequent dissolution (days 14–73). Experiments with the smallest size fraction resulted in the highest Ca, Si and V concentrations, highlighting the role of surface area in controlling initial leaching. After ~2 weeks, the solution Ca/Si ratio (0.7–0.9) evolved to equal those found within a Ca–Si–H phase that replaced dicalcium silicate and free-lime phases in a 30- to 150-μm altered surface region. V release was a two-stage process; initially, V was released by dicalcium silicate dissolution, but V also isomorphically substituted for Si into the neo-formed Ca–Si–H in the alteration zone. Therefore, on longer timescales, the release of V to solution was primarily controlled by considerably slower Ca–Si–H dissolution rates, which decreased the rate of V release by an order of magnitude. Overall, the results indicate that the BOF slag leaching mechanism evolves from a situation initially dominated by rapid hydration and dissolution of primary dicalcium silicate/free-lime phases, to a slow diffusion limited process controlled by the solubility of secondary Ca–Si–H and CaCO3 phases that replace and cover more reactive primary slag phases at particle surfaces.

Study on volatilization behaviour of BOF converter slag containing CaCl2

The volatilization behaviour of typical fluorine-containing slag in steelmaking

Vaporization Behaviors of Zn in FetO-CaO-SiO2-Al2O3 Slag System

Free CaO Stabilisation by Mixing of BF Slag and BOF Slag in Molten State

Effect of Cr2O3 on Physicochemical Properties of CaO-SiO2-FetO Slags during BOF Smelting Process of Chromium-Bearing Iron

Numerical Investigation of Basic Oxygen Furnace Slag Modification with Gas Bottom-Blowing and SiO2 Modifier

Qualitative, Quantitative and Mechanism Research of Volatiles in the Most Commonly Used CaO–SiO2–CaF2–Na2Ο Slag During Casting Process

Stabilization of Free CaO in Molten BOF Slag by Addition of Silica at High Temperature

Qualitative, Quantitative and Mechanism Research of Volatiles in the Most Commonly Used CaO–SiO 2 –CaF 2 –Na 2 Ο Slag During Casting Process

Comparative Analysis on the Vaporization Behavior of Zinc and Lead in Molten Slag System

Volatilization characteristics of high-lead slag and its influence on measurement of physicochemical properties at high temperature

Hydration of dicalcium silicate and diffusion through neo-formed calcium-silicate-hydrates at weathered surfaces control the long-term leaching behaviour of basic oxygen furnace (BOF) steelmaking slag

Mineral Sequestration of CO2 Using Basic Oxygen Furnace (BOF) Steelmaking Slag

Influence of B2O3 on the Thermophysical Properties of Molten Blast Furnace Slag

Vaporization Behavior of Lead from the FeO-CaO-SiO2-Al2O3 Slag System

Study on f-CaO digestion mechanism of high alkalinity slags with iron ore tailings

Accelerated carbonation and stabilization of BOF slag: data fitting relationship between particle size and CO2 sequestration

Effect of Composition on the Crystallisation Behaviour of Blast Furnace Slag Using Single Hot Thermocouple Technique

Effect of superheat degree and MnO on structural characteristics of CaO-SiO 2 -TiO 2 -based blast furnace slags

Study on Characteristics of Steel Slag for CO2 Capture

Evolution of Interface Characteristic between Quicklime and CaO–SiO2–FetO–MgO Melt during Slag‐Forming Procedure in Converter under Different Times