Abstract:Die filling from a stationary shoe in a vacuum and in the presence of air was numerically, analyzed using an Eulerian-Lagrangian model, which employs a discrete element method (DEM) for the particles and computational fluid dynamics (CFD) for the air with a two-way air-particle interaction coupling term. Monodisperse and polydisperse powder systems have been simulated to explore the effect of the presence of air on the die filling process. For die filling with monodisperse powders, the influences of particle size and density on the flow behavior were explored. The numerical simulations revealed that the presence of air has a significant impact on the powder flow behavior, especially for systems with smaller and/or lighter particles. Flow has been characterized in terms of a dimensionless mass flow rate, and it has been shown that for die filling in a vacuum this is constant. The flow characteristics for die filling in air can be classified into two regimes. There is an air-inert regime in which the particle size and density are sufficiently large that the effect of air flow becomes negligible, and the dimensionless mass flow rate is essentially identical to that obtained for die filling in a vacuum. There is also an air-sensitive regime, for smaller particle sizes and lower particle densities, in which the dimensionless mass flow rate increases as the particle size and density increase. The effects of particle-size distribution and adhesion on the flow behavior have also been investigated. It was found that, in a vacuum, the dimensionless mass flow, rate for polydisperse systems is nearly identical to that for monodisperse systems. In the presence of air, a lower dimensionless mass flow rate is obtained for polydisperse systems compared to monodisperse systems, demonstrating that air effects become more significant. Furthermore, it has been shown that, as expected, the dimensionless mass flow rate decreases as the surface energy increases (i.e., for more cohesive powders). (C) 2008 American Institute of Chemical Engineers AIChE J, 55: 49-62, 2009

Powder transport behavior in RH degasser with powder injection through up snorkel: a transient numerical model

Powder Injection Effect on Hot Metal Desulfurization Behavior in the Kanbara Reactor: a Transient 3D Coupled Numerical Model

Effect of Interphase Forces on Gas–Liquid Multiphase Flow in RH Degasser

Modeling on the Desulfurization of the Molten Steel During RH Process

A Coupled Dem/Cfd Analysis of the Effect of Air on Powder Flow During Die Filling

A Coupled DEM/CFD Analysis of Die Filling Process

The effects of air and particle density difference on segregation of powder mixtures during die filling

Numerical Simulation Study of Co-injection of Pulverized Coal and Hydrogen in the Tuyere-Raceway

Powder Discharge from a Hopper-Standpipe System Modelled with CPFD

Numerical studies of heat transfer parameters during injection feeding of powders into the rail steel melt in ladle-furnace

Powder flow simulation of a ring-type coaxial nozzle and cladding experiment in laser metal deposition

Simulation of powder transportation in directed energy deposition

Influences of three-route gas flows on powder converging behavior in coaxial powder feeding nozzles

Bubble formation by argon injection through the down-leg snorkel with Ruhrstahl–Heraeus (RH) circulating flow

Numerical Simulation on the Effects of Powder Size on a Two-Phase Flow in a Slot-Plug Mixing Chamber

Numerical Simulation on Gas-liquid Flow in Mechanical-Gas Injection Coupled Stirred System

Characteristics of the Dead Zones in RH Desgasser with Simulation Methods

Effect of Injection Angle on Particles In-Flight Characteristics

Modeling of Motion of Inclusions in Argon‐Stirred Steel Ladles

Simulation Analysis of Influence of Argon Gas Injection Hole Position on Flow Field in Steel Ladle

Investigation of molten pool geometry and flow field based on powder-scale modeling in laser directed energy deposition