Abstract:The reason that p-GaN gate normally-off high electron mobility transistor (HEMT) device is able to draw prevail interests is not only for its outstanding electric properties of low on-resistance and high thermal conductivity, but also for its applications under high frequency and high voltage. In HEMT devices, the setting of Al component in the AlGaN barrier layer is a key parameter to affect the formation of two-dimensional electron gas (2DEG) at the AlGaN/GaN heterojunction, and therefore directly determines the performance of the devices. This paper uses the Atlas module of the Silvaco-TCAD software to design and simulate p-GaN gate normally-off HEMT devices to investigate the effect of Al mole fraction content in the AlGaN barrier layer on the electrical performance, as well as the causes in terms of the conduction band energy structure diagram. The results show that the threshold voltage of the HEMT device decreases, the maximum saturation drain current increases, and the peak transductance of the HEMT device increases with increasing the Al content. In the off-state (zero gate voltage), the AlGaN/GaN potential well depth becomes deeper as the Al mole fraction increases, resulting in a lower driven force to rebuild the minimized 2DEG concentration in the GaN layer for switching from off-state to on-state, and this leads to a lower threshold voltage. While, in the on-state (5 V gate voltage), the deeper AlGaN/GaN potential well depth as the Al mole fraction increases, the higher of the 2DEG concentration of the GaN layer, leading to a higher maximum saturation output drain current. After optimization, the integrated electrical performance of the HEMT devices has been found best when the Al mole fraction content is about 0.25. The results obtained from the simulations are helpful for the experimental design of p-GaN gate normally-off HEMT devices

Fluoride monolayer doping in GaN/AlGaN/GaN semiconductor

Self-assembled monolayer gate doping and their detail deep cryogenic characterization of GaN/Si HEMTs

Self-aligned enhancement-mode AlGaN/GaN HEMTs using 25 keV fluorine ion implantation

Improving the Manufacturability of Low-Temperature GaN Ohmic Contact by Blocking the Fluorine Ion Injection

Threshold voltage control by gate oxide thickness in fluorinated GaN metal-oxide-semiconductor high-electron-mobility transistors

High Breakdown Voltage and Low Dynamic ON-Resistance AlGaN/GaN HEMT with Fluorine Ion Implantation in SiNx Passivation Layer

Sub-nanometer ultrathin epitaxy of AlGaN and its application in efficient doping

Normally-Off InAlN/GaN Fin-MOSHEMT with Fluorine Treatment

Enhancement-Mode Algan/Gan Hemts Fabricated by Standard Fluorine Ion Implantation with A Si3n4 Energy-Absorbing Layer

The Effect of Fluorine Doping in the Charge Trapping Layer on Device Characteristics and Reliability of E-Mode GaN MIS-HEMTs

On The Stability Of Fluorine Ions In Algan/Gan Heterostructures: A Molecular Dynamics Simulation Study

Molecular Dynamics Simulation Study on Fluorine Plasma Ion Implantation in AlGaN/GaN Heterostructures

Improvement of the Off-State Breakdown Voltage With Fluorine Ion Implantation in AlGaN/GaN HEMTs

First-principles calculations for effects of Fluorine impurity in GaN

High- ${k}$ HfO 2 -Based AlGaN/GaN MIS-HEMTs with Y 2 O 3 Interfacial Layer for High Gate Controllability and Interface Quality

Effect of fluorinated graphene insulator on AlGaN/GaN MIS-HEMTs as gate dielectric

Simulation study on electrical properties of p-GaN gate normally-off HEMT devices affected by Al mole fraction in AlGaN barrier layer

The DC Performance and RF Characteristics of GaN-Based HEMTs Improvement Using Graded AlGaN Back Barrier and Fe/C Co-Doped Buffer

Gate and barrier layer design of E-mode GaN HEMT with p-GaN gate structure

High Threshold Voltage Stability Enhancement-Mode GaN p-FETs Fabricated With PEALD-AlN Gate Interfacial Layer

On the Stability of Fluorine Ions in AlGaN/GaN System: a Theoretical Study