Abstract:This paper aims to explore the evolution of microstructural parameters induced during the cutting of Ti6Al4V alloy (TC4). The microstructure characteristics of the workpiece material is directly tied to its mechanical response during machining. During TC4 cutting, microstructure evolution is observed as a result of severe plastic deformations. The characterization of this phenomenon has significant interest from both academia and industry. In this work we present a developed modeling technique which combines the Particle Finite Element Method (PFEM) with incremental homogeneous field distributions. First, the PFEM is extended to perform a thermo-mechanical analysis capable of capturing the material responses of TC4 during orthogonal cutting. To generate serrated chips, an appropriate strain softening-based constitutive plasticity model i.e., TANH (Hyperbolic TANgent) is utilized. The PFEM's validity is checked through comparison with available experimental results in terms of chip shapes and cutting forces. Second, the evolution of microstructural parameters such as dislocation density, vacancy concentration, dynamic recrystallization (DRx) grain size, and hardness is incrementally developed and incorporated into the PFEM using internal state variables as homogeneous field distributions. The Johnson–Mehl–Avrami–Kolmogorov (JMAK) model and Hall–Petch equation are applied for predicting grain size and hardness, respectively. The parameters of the corresponding models are modified for TC4 to accurately capture their alterations. Lastly, the predicted results of the microstructure evolution in serrated chips and machined surfaces, including average grain size and hardness, are compared with experiments, demonstrating good agreement. This implies that the PFEM combined with microscale schemes can reliably simulate the machining process of the TC4.

Determination of the Cutting-Edge Microgeometry Based on Process Forces during Peripheral Milling of Ti-6Al-4V Using Machine Learning

Numerical Simulation Study on Milling Force for Aerospace Aluminum Alloy

Milling Error Prediction of Thin-Walled Parts During High-Speed Machining

Finite element simulation of residual stress in machining of Ti-6Al-4V with a microstructural consideration

Modelling and Optimization of Machining of Ti-6Al-4V Titanium Alloy Using Machine Learning and Design of Experiments Methods

A prediction model for the milling of thin-wall parts considering thermal-mechanical coupling and tool wear

Investigation of the tool flank wear influence on cutter-workpiece engagement and cutting force in micro milling processes

Prediction of Cutting Forces in Milling Using Machine Learning Algorithms and Finite Element Analysis

Online monitoring model of micro-milling force incorporating tool wear prediction process

An analytical micro-milling force model based on the specific cutting pressure-feed dependence, in presence of ploughing and tool run-out effects

FEM-supported machine learning for residual stress and cutting force analysis in micro end milling of aluminum alloys

Microstructure evolution modeling of Ti6Al4V alloy during cutting using the Particle Finite Element Method and homogeneous field distributions

Generic Cutting Force Modeling Comprehensively Considering Tool Edge Radius, Tool Flank Wear and Tool Runout in Micro-End Milling

Prediction of tool wear during micro-milling Inconel 718 based on long short-term memory network

Predicting Surface Residual Stress for Multi-Axis Milling of Ti-6Al-4V Titanium Alloy in Combined Simulation and Experiments

Prediction of Surface Residual Stress after End Milling Based on Cutting Force and Temperature

Micro milling force prediction of arc thin-walled parts considering dual flexibility coupling deformation

In-process Tool Wear Prediction System Based on Machine Learning Techniques and Force Analysis

Micro-milling force modeling with tool wear and runout effect by spatial analytic geometry

Prediction of residual stress with multi-physics model for orthogonal cutting Ti-6Al-4V under various tool wear morphologies

Modeling of cutting forces in 1-D and 2-D ultrasonic vibration-assisted milling of Ti-6Al-4V