Abstract:On water impact, a projectile experiences impact forces that can threaten its structural safety and the stability of its trajectory. In the engineering applications , the underwater vehicle may need to entry and exit of water several times. The elastic buffer can be used repeatedly, which meet the requirement of the scene. To mitigate the effects of a strong impact, a projectile with a spring buffer connecting its main body and disk is designed in this work. The impact force of the main body during water entry is studied experimentally. The experimental equipment and the force measurement system are newly developed by the authors. The main focus is the cavity evolution and the axial force of the main body. The cavity of the projectile with a buffer is slightly elongated and thickened compared with that without a buffer. A special necking phenomenon of the cavity is observed as the spring buffer is compacted. The effects of the spring stiffness , the disk mass, and the impact velocity on the axial force and impulse are extensively discussed. Compared with the case without a buffer, the axial force of the main body is only mitigated within a small range of stiffness values. When the stiffness increases, the axial force begins to fluctuate with a larger peak and a narrow pulse. The peak force is nearly twice that in the case without a buffer. However, the impulse is always smaller, although some fluctuations occur in the larger stiffness cases. Additionally, an increased disk mass can also mitigate the force peak and the impulse of the main body, but fluctuations also occur in cases with larger masses. The coefficients of the axial force and the impulse of the main body decrease with increasing impact velocities. The result indicates that the elastic buffer only in a narrow stiffness can effectively reduce the impact load of the water entry projectile. This study can provide references for the load reduction design of the projectile with an elastic buffer during water entry or exit.

Design of Combined Buffer on a High-precision Weapon

Application of High Kinetic Energy Buffer Control Technology after Free Recoil

Design and Dynamic Characteristics of a Double-Layer Permanent-Magnet Buffer under Intensive Impact Load

Numerical Simulation of the Two-phase Flow of a Constant-pressure Rear-spray Low Recoil Weapon with Two Chambers

Dynamics Simulation of Floating Automatic Rifle

Experimental study of recoil reduction by reverse jet gas for automatic weapon

Research on the application of magnetorheological fluids in artillery buffer system

A high-energy liquid-jet hammer with specially designed backward stroke end buffer structure

Research on Launching Technique of Varying Firing Rate for Automatic Rifle

Research on Disc Spring Buffering the Backward Impact of Piston of Liquid-Jet Hydraulic Hammer Based on LS-DYNA

The Buffer of On-board Test Circuit Module in High G Shock

Experimental investigation on the impact force of the oblique water entry of a slender projectile with spring buffer

Launch Dynamics Analysis of a Grenade Machine Gun with High Muzzle Velocity Based on the Soft Recoil Technology

Study on Micro Recoil Mechanism of the Weapon with a Nozzle and Two Chambers Separated by a Partition

The Study of Buffer Structure of On-Board Test's Circuit Module in High Shock

Influences Research of Impact Factors on Gun Recoil Tester

Design and simulation research on experimental equipment of gun recoil

Dynamic Modeling and Simulation of Gatling Gun with Muzzle Assistant-Rotating and Recoil Absorber

Study on Low Recoil Floating Technology of Large-caliber Machine Gun

Design and analysis of a scheme for the naval gun test shell entering the bore

Design of Shock Isolator under Recoil Shock