Abstract:A phase-field description of brittle fracture is employed in the reported four-point bending analyses of monolithic and laminated glass plates. Our aims are: (i) to compare different phase-field fracture formulations applied to thin glass plates, (ii) to assess the consequences of the dimensional reduction of the problem and mesh density and refinement, and (iii) to validate for quasi-static loading the time-/temperature-dependent material properties we derived recently for two commonly used polymer foils made of polyvinyl butyral or ethylene-vinyl acetate. As the nonlinear response prior to fracture, typical of the widely used Bourdin–Francfort–Marigo model, can lead to a significant overestimation of the response of thin plates under bending, the numerical study investigates two additional phase-field fracture models providing the linear elastic phase of the stress-strain diagram. The typical values of the critical fracture energy and tensile strength of glass lead to a phase-field length-scale parameter that is challenging to resolve in the numerical simulations. Therefore, we show how to determine the fracture energy concerning the applied dimensional reduction and the value of the length-scale parameter relative to the thickness of the plate. The comparison shows that the phase-field models provide very good agreement with the measured stresses and resistance of laminated glass, despite the fact that only one/two cracks are localised using the quasi-static analysis, whereas multiple cracks evolve during the experiment. It was also observed that the stiffness and resistance of the partially fractured laminated glass can be well approximated using a 2D plane-stress model with initially predefined cracks, which provides a better estimation than the one-glass-layer limit.

Simulation of the Crack Resistance of Ion-Exchange Strengthened Silicate Glass Subject to Bending Strain

The Competing Effect of Initial Crack Depth Versus Chemical Strengthening Parameters on Apparent Fracture Toughness of Sodium Aluminosilicate Glass

Micro‐scale mechanical properties of surface layer in ion‐exchanged glass

Smeared fixed crack model for quasi-static and dynamic biaxial flexural response analysis of aluminosilicate glass plates

Phase-Field Fracture Modelling of Thin Monolithic and Laminated Glass Plates under Quasi-Static Bending

Evaluating the residual stresses and fracture behavior of glass-ceramics by numerical modeling

A Numerical Simulation of a Ni-based Bulk Metallic Glass During Compressive Deformation and Fracture

Fracture of silicate glasses: Micro-cavities and correlations between atomic-level properties

Crack arrest and stress dependence of laser-induced surface damage in fused-silica and borosilicate glass

Experimental evaluation of the numerical simulation adequacy for a laminate glass-epoxy composite interlayer crack resistance under mixed mode I/II loading

033 Crack initiation and path prediction of float glass with various constrain conditions under thermal loading

Enhancing bending performance of ultrathin flexible glass through chemical strengthening

Delayed fracture of ion‐exchange strengthened alkali‐aluminosilicate glass

Peridynamic simulation for the damage patterns of glass considering the influence of rate-dependence and pre-defects

Constant-curvature bending response of thin glass: Analytical, numerical and experimental study of “clamp-bending” tests

Comparative Study on Crack Initiation and Propagation of Glass under Thermal Loading

Surface damage resistance and yielding of chemically strengthened silicate glasses: From normal indentation to scratch loading

Evaluation of crack initiation load of silica glass surfaces formed during subcritical crack growth

Development of a dynamic model for crack propagation in glazing system under thermal loading

Crack-tip strain field mapping and the toughness of metallic glasses

Simulating progressive failure in laminated glass beams with a layer-wise randomized phase-field solver