Hydrogen storage and heat transfer properties for large-capacity double thin-layered annulus ZrCo bed with secondary containment cavity
Rongxing Ye,Huaqin Kou,Wenhua Luo,Jinchun Bao,Xu Huang,Fudong Jiang,Tao Tang,Zhiyong Huang,Ge Sang,Yulong Li
DOI: https://doi.org/10.1016/j.ijhydene.2021.12.196
IF: 7.2
2022-01-01
International Journal of Hydrogen Energy
Abstract:Fast heat and mass delivery with high cycling stability of the core component, hydrogen storage bed, in SDS are essential for the operation of the future tritium factory in ITER project. However, the aforementioned properties are still perplexing in large-capacity ZrCo bed, especially for that with secondary containment structure required by the actual tritium operation in the future. Herein, the performance including heating, cycling and cooling with two different size ZrCo beds (loading of ZrCo are 200 g and 2000 g respectively) were systematically studied. The experimental data shows that the maximum heating ability of the middle-size/full-scale storage bed are both about 10 degrees C/min, and the maximum hydrogen absorption capacity of these ZrCo beds are 44.6 L/405.5 L, respectively. Besides, hydrogen pressure and hydrogen retention during the following desorption can affect the cycling performance of the ZrCo bed. The use of transfer pump can reduce the pressure of the bed during the hydrogen desorption process (operated at 500 degrees C), which inhibits the disproportionation reaction of the ZrCo alloy. However, the degree of hydrogen pressure reduction in two the types of ZrCo bed are different. As a result, the cycling capacity of the middle-size bed (93.4%, lower hydrogen pressure) is higher than the full-scale bed (68.7%, higher hydrogen pressure) after 10 cycles. When the transfer pump was not used and operated at lower temperature (350 degrees C), the beds cannot release hydrogen completely, and partial hydrogen atoms are retained in the ZrCo alloy. The middle-size bed still maintains a hydrogen storage capacity of 94.5% after 10 cycles, while 75.9% of the hydrogen storage capacity remained for the full-scale bed. Therefore, the increase of hydrogen surplus in ZrCo alloy is helpful to improve its cycling stability. At last, the cooling performances of the beds under 10 different cooling methods were studied. Among the cooling methods, the best cooling rate was achieved by filling nitrogen in the secondary containment cavity and flowing water passing through the cooling circuit of the bed. This work will provide a crucial reference for the design and optimization of the subsequent operation technology of SDS in ITER. (C) 2021 Hydrogen Energy Publications LLC. Published by Elsevier Ltd. All rights reserved.