Abstract:A fast and accurate grid impedance measurement of three-phase power systems is crucial for online assessment of power system stability and adaptive control of grid-connected converters. Existing grid impedance measurement approaches typically rely on pointwise sinusoidal injections or sequential wideband perturbations to identify a nonparametric grid impedance curve via fast Fourier computations in the frequency domain. This is not only time-consuming, but also inaccurate during time-varying grid conditions, while on top of that, the identified nonparametric model cannot be immediately used for stability analysis or control design. To tackle these problems, we propose to use parametric system identification techniques (e.g., prediction error or subspace methods) to obtain a parametric impedance model directly from time-domain current and voltage data. Our approach relies on injecting wideband excitation signals in the converter's controller and allows to accurately identify the grid impedance in closed loop within one injection and measurement cycle. Even though the underlying parametric system identification techniques are well-studied in general, their utilization in a grid impedance identification setup poses specific challenges, is vastly underexplored, and has not gained adequate attention in urgent and timely power systems applications. To this end, we demonstrate in numerical experiments how the proposed parametric approach can accomplish a significant improvement compared to prevalent nonparametric methods.

An Observer-Based Composite Identifier for Online Estimation of the Thevenin Equivalent Parameters of a Power System

An observer‐based composite identifier for online estimation of the Thévenin equivalent parameters of a power system

ON-LINE IDENTIFICATION OF POWER SYSTEM DYNAMIC EQUIVALENT Part Two Parameter Estimation & Simulation

Dynamic Equivalents of Power Systems with Online Measurements. Part 1: Theory

On-line identification of power system dynamic equivalent: Part One: Models and Identifiability

Identification Approach to Dynamic Equivalents of the Power System Interconnected with Three Areas

Dynamic Equivalents of Power Systems with Online Measurements Part 2: Applications

ON-LINE IDENTIFICATION OF POWER SYSTEM DYNAMIC EQUIVALENT Part Three Analysis of Several Important Issues

Online Thevenin Equivalent Parameter Estimation using Nonlinear and Linear Recursive Least Square Algorithm

Thévenin Equivalent Parameters Identification Based on Statistical Characteristics of System Ambient Data

Network Parameter Identification and Estimation Based on Hybrid Measurement of WAMS/SCADA

Identifiability Implies Robust, Globally Exponentially Convergent On-line Parameter Estimation: Application to Model Reference Adaptive Control

Online Parameter Estimation Considering Input Errors for Synchronous Generation Systems

Online SSO Stability Analysis-Based Oscillation Parameter Estimation in Converter-Tied Grids

Multi-scenario parallel interior algorithm for generator parameter identification in power systems

Hybrid multi-observer for improving estimation performance

MIMO Grid Impedance Identification of Three-Phase Power Systems: Parametric vs. Nonparametric Approaches

Exponential Modulation Integral Observer for Online Detection of the Fundamental and Harmonics in Grid-Connected Power Electronics Equipment

Synchrophasor-based Online State Estimated in Large-scale Power Grid

Accurate Voltage Parameter Estimation for Grid Synchronization in Single-Phase Power Systems

A Two-Level Online Parameter Identification Approach