Abstract:This paper proposes a novel method for identifying Thévenin equivalent parameters (TEP) in power system, based on the statistical characteristics of the system's stochastic response. The method leverages stochastic fluctuation data under steady-state grid conditions and applies sliding window techniques to compute sensitivity parameters between voltage magnitude, current magnitude and power. This enables high-accuracy and robust TEP identification. In contrast to traditional methods, the proposed approach does not rely on large disturbances or probing signals but instead utilizes the natural fluctuation behavior of the system. Additionally, the method supports distributed implementation using local measurements of voltage magnitude, current magnitude, and power, offering significant practical value for engineering applications. The theoretical analysis demonstrates the method's robustness in the presence of low signal-to-noise ratio (SNR), asynchronous measurements, and data collinearity issues. Simulation results further confirm the effectiveness of the proposed method in diverse practical scenarios, demonstrating its ability to consistently provide accurate and reliable identification of TEP using system ambient data.
What problem does this paper attempt to address?
This paper attempts to solve the problem that traditional methods are difficult to accurately identify Thévenin equivalent parameters (TEP) under the steady - state conditions of power systems. Specifically:
1. **Limitations of traditional methods**:
- Traditional methods rely on large disturbances or probe signals to improve the signal - to - noise ratio (SNR) and thus enhance the accuracy of TEP identification. However, under steady - state conditions, large disturbances occur less frequently, and the power system usually maintains a stable topology and operation mode. Therefore, electrical measurements are mainly affected by random fluctuations, such as load changes and changes in renewable energy output.
- These random fluctuations are superimposed on the steady - state operation, and the information provided is not sufficient to support traditional methods for reliable parameter identification, especially under low SNR conditions.
2. **Objectives of the new method**:
- The paper proposes a new method based on the statistical characteristics of the system's random response for identifying Thévenin equivalent parameters under steady - state conditions. This method uses the sliding - window technique to calculate the sensitivity parameters between voltage amplitude, current amplitude and power, thereby achieving high - precision and robust TEP identification.
- The new method does not rely on large disturbances or probe signals but utilizes the natural fluctuation behavior of the system and can be implemented in a distributed manner, using locally measured voltage amplitude, current amplitude and power data, which has significant practical application value.
3. **Key contributions**:
- **Identification method based on statistical characteristics**: By calculating the statistical characteristics of random fluctuations through the sliding - window technique, the sensitivity parameters between voltage amplitude, current amplitude and power are accurately estimated, thereby achieving high - precision TEP identification using only environmental data.
- **Robustness under low SNR**: Since the correlation of the statistical characteristics of the measurement data is different from that of random fluctuations and measurement noise, the new method exhibits higher TEP identification accuracy under low SNR conditions.
- **Robustness under asynchronous measurement**: The relative error of the statistical characteristics within the sliding window is lower than that of the original data, which improves the TEP identification accuracy in the case of asynchronous measurement.
- **Handling data collinearity**: This method does not significantly increase the correlation or condition number of the data, and the optimal method can be selected in the presence of low SNR, asynchronous measurement and data collinearity.
Through these improvements, the paper aims to provide a new method for efficiently and accurately identifying Thévenin equivalent parameters under steady - state conditions, overcoming the limitations of traditional methods in practical applications.