Abstract:Bad measurements identification is an important problem for system monitoring and controlling in electric power system. In recent years, some studies have shown that the bad measurements can be corrected by some state estimation methods. However, most of the studies mainly focus on a single measurement snapshot but ignoring the possibility of the continuous measurement errors existence in historical measurement data. In this paper, we propose an algorithm for identification of bad measurements from historical measurements. And considering the different occurrence pattern of bad measurements, we propose a more common situation of bad measurements which is a continuous error in multi-snapshots of measurements rather than a single one. In our method, we use a least-square optimization model as the basic estimator to get the initial results of measurement residuals. After that we set a searching strategy based on hypothesis test and normalized measurement residuals to find a continuous errors in historical measurement data. Then we update the computation of the basic estimator to correct the biases in state variables caused by bad measurements, which lead to more precise results of system states. The performance of the developed identification algorithm is demonstrated and compared with conventional estimation methods based on experiments using IEEE 30-bus systems.

Research on ambient signals based closed-loop identification of power system

Closed-Loop Identification of Power System Based on Ambient Data

A New Iterative Identification and Control Method of Closed-Loop Power System Based on Ambient Signals

ON-LINE IDENTIFICATION OF POWER SYSTEM DYNAMIC EQUIVALENT Part Three Analysis of Several Important Issues

Research on identification algorithms applicability for power grid damping online monitoring

ON-LINE IDENTIFICATION OF POWER SYSTEM DYNAMIC EQUIVALENT Part Two Parameter Estimation & Simulation

A New Optimized Method of Excitation Signal for Closed-Loop Identification of Power System Based on Ambient Signals

Network Parameter Identification and Estimation Based on Hybrid Measurement of WAMS/SCADA

Improvement of Electromechanical Mode Identification from Ambient Data with Stochastic Subspace Method

Hybrid Frequency-Domain Modeling and Stability Analysis for Power Systems with Grid-Following and Grid-Forming Converters

Research on the Identification of Dominant Dynamic Parameters of Power System

A two-stage framework for ambient signal based load model parameter identification

General formulation of transfer function identification for power system based on WAMS

Estimation of the electromechanical characteristics of power systems based on a revised stochastic subspace method and the stabilization diagram

Multiple Line Outage Detection for Power Systems under Multi-Parameter Uncertainty

Estimating The Electromechanical Oscillation Characteristics Of Power System Based On Measured Ambient Data Utilizing Stochastic Subspace Method

Identification of Bad Measurements in Power System from Historical Measurement Data

Real Time Small Signal Stability Analysis of Power Systems Interconnected by Ultra High Voltage Transmission Line

Identification of Oscillation Phase Relationship among Nodes Based on Wide Area Measured Ambient Signals

Analytic Estimation Method of Forced Oscillation Amplitude under Stochastic Continuous Disturbances

Ambient signals based power system oscillation modes identification considering model order selection