Abstract:Abstract Due to population growth, the need for energy, especially fossil fuels, is increased every year. Since the costs of exploring new reservoirs and drilling new wells are very high, most reservoirs have passed their first and second periods of life, and it is necessary to use EOR methods. Water-based enhanced oil recovery (EOR) methods are one of the popular methods in this field. In this method, due to the possibility of emulsion formation is high, and by creating a stable emulsion, viscosity and mobility improved. In this study, the parameters affecting the stability and viscosity of the emulsion have been investigated step by step. In the first step, 50% (v/v) of water has been selected as the best water cut. The type of salt and its best concentration was evaluated in the second step by measuring the average droplets size. The third step investigated the effect of SiO 2 nanoparticles and surfactant (span80) on emulsion stability and viscosity. According to the results, the best amount of water cut was 50% due to the maximum viscosity. In salts the yield was as follows: MgCl 2 > CaCl 2 > MgSO 4 > Na 2 SO 4 > NaCl. The best yield was related to MgCl 2 at a concentration of 10,000 ppm. Finally, it was shown that the synergy of nanoparticles and surfactants resulted in higher stability and viscosity than in the case where each was used alone. It should be noted that the optimal concentration of nanoparticles is equal to 0.1% (w/w), and the optimal concentration of surfactant is equal to 200 ppm. In general, a stable state was obtained in 50% water-cut with MgCl 2 salt at a concentration of 10,000 ppm and in the presence of SiO 2 nanoparticles at a concentration of 0.1% and span 80 surfactants at a concentration of 200 ppm. The results obtained from this study provide important insights for optimal selection of the water-based EOR operation parameters. Viscosity showed a similar trend with stability and droplet size. As the average particle size decreased (or stability increased), the emulsion viscosity increased.

Variation of Extraction Yield and Droplet Size during Emulsification Solvent Extraction of Wet-Process Phosphoric Acid

Behavior of Soybean Phosphatidylcholine in Silica-Gel Liquid Chromatography

PREPARATION OF EXTRACTANT MICROCAPSULES BY SOLVENT EVAPORATION METHOD

Wet process phosphoric acid purification by solvent extraction using N-octanol and tributylphosphate mixtures

Modeling the Solidification of O/W-Emulsion Droplet in Solvent Evaporation Technique

Purification of Phosphoric Acid by Solvent Extraction

Optimization of operating conditions in purification of wet process phosphoric acid in a liquid-liquid extraction column

Experimental Study on the Synergistic Effect between Evaporation Weathering and Emulsification of Oil Spills

Optimizing Procedures of Ultrasound-Assisted Extraction of Waste Orange Peels by Response Surface Methodology

Phosphoric Acid Purification by Suspension Melt Crystallization: Parametric Study of the Crystallization and Sweating Steps

The Influence of Emulsification Dynamics and Temperature to Emulsify

Effect of chemicals on the phase and viscosity behavior of water in oil emulsions

Numerical modeling and experimental verification of ceramic membrane emulsification for stable emulsion production

An Experimental Study of Immiscible Liquid–liquid Dispersions in a Pump–mixer of Mixer–settler

Effect of Diluents on the Extraction of Oxalic Acid by Trialkylphosphine Oxide

MECHANISM OF EXTRACTANT LOSS IN SOLVENT-EXTRACTION PROCESS .1. TRANSFER OF SAPONIFIED D2EHPA FROM ORGANIC-PHASE TO AQUEOUS-PHASE AND ITS AGGREGATION BEHAVIOR

A New Process for Purifying Wet-Process Phosphoric Acid by Solvent Extraction

Study and Optimization of Amino Acid Extraction by Emulsion Liquid Membrane

Raman spectroscopy and molecular dynamics simulations of aqueous two-phase systems for the purification of phosphoric acid.

Dynamic of centrifugal step emulsification and prediction of droplet diameter

EXTRACTION EQUILIBRIUM CHARACTERISTICS OF DICARBOXYLIC ACIDS WITH TRIALKYLPHOSPHINE OXIDE AS EXTRACTANT AND 1-OCTANOL AS DILUENT