Abstract:Icing is a serious threat to the flight safety of aircraft. Lightweight and efficient electrothermal de-icing systems for carbon fiber reinforced polymer components are expected to contribute to the lightweighting and electrification of aircraft. This study presents the development and test of a novel, integrated, multifunctional composite electrothermal ice protection system. The system achieves this by incorporating a carbon-based ultra-thin flexible heating film into a carbon fiber-reinforced polymer composite laminate. T700 and M40 carbon fiber prepregs were used. The system composition and configuration were designed based on the anisotropic mechanical and thermal properties of the carbon fiber-reinforced polymer composite. The effects of ply stacking sequence, presence of insulation layer, ply angle, heating area, and prepreg type on thermal response and de-icing performance were investigated. Thermal response experiments were carried out in both room temperature and low temperature environments. A one-dimensional thermal response analysis model was developed for a representative heating structure. Comparative de-icing experiments were conducted on different samples in a low-temperature test chamber. A numerical model, based on the modified enthalpy-porosity method, was developed to simulate the de-icing process, and showed good agreement with the experimental results. Experiments and numerical calculations show that the arrangement of the heater close to the deicing surface improves the performance of the electrothermal deicing system while maintaining the overall mechanical properties of the multi-layer structure. While the insulation layer helps marginally with heat loss during de-icing, it significantly increases the system’s thermal inertia, which delays the de-icing’s start. It is recommended to minimize or eliminate insulation layer thickness. Rapid de-icing effects, combined with energy conservation, can be achieved through a short-term, high-power heating strategy.

Development of a small and transportable de-icing/anti-icing drone-mounted system. Part 2: Prototype testing and proof of concept

Development of a small and transportable de-icing/anti-icing drone-mounted system. Part 1: System design

Induction Heating Characteristics of Electroless Ni-Coated CFRP for Deicing and Anti-Icing

An Experimental Apparatus for Icing Tests of Low Altitude Hovering Drones

Advancements in De-icing and Anti-icing Technologies used in Aircraft

Integrated Composite Electrothermal De-Icing System Based on Ultra-Thin Flexible Heating Film

Effect of Various Surface Coatings on De-Icing/Anti-Icing Fluids Aerodynamic and Endurance Time Performances

Bi-Level Optimization for De-Icing Position Allocation and Unmanned De-Icing Vehicle Fleet Routing Problem

Experimental Study on the Effects of Substrate Hydro-/Icephobicity on Ice Mitigation and Ice Shedding During the Dynamic Icing Process over the Rotating Propeller of an Unmanned-Aerial-Vehicle

Development of ICE/NO-ICE Sensor System for in-Flight Ice Detection

Progress in the Development of Practical Remote Detection of Icing Conditions

Full-scale tests of deicing with seawater

FireDrone: Multi‐Environment Thermally Agnostic Aerial Robot

Surface Acoustic Waves Equip Materials with Active Deicing Functionality: Unraveled Deicing Mechanisms and Application to Centimeter Scale Transparent Surfaces

Deicing Robot Design Based on ANSYS Simulation

Icephobic Gradient Polymer Coatings Coupled with Electromechanical De‐icing Systems: A Promising Ice Repellent Hybrid System

Computational simulation of aircraft electrothermal de-icing using an unsteady formulation of phase change and runback water in a unified framework

Mechanical System Design and Motion Space Analysis For Transmission Line Insulators Laser Deicing Robot

Development of a Computational Fluid Dynamics Model for Ice Formation: Validation and Parameter Analysis

An New Idea on Anti-icing and De-icing of Helicopter Rotor Blade

Study on thermodynamic coupling behavior of non-Newtonian deicing fluid droplets impinging on solid walls at low temperature