Abstract:The prevention of ice build-up on aircraft surfaces is crucial for safe operations. Thermal ice protection systems, particularly electro-thermal systems, are commonly employed to mitigate ice formation. However, the weight of electric batteries used in these systems significantly impacts aircraft performance, necessitating the minimization of power load during design. Despite this requirement, effective anti-icing operation mandates a sufficient heat flux to maintain surface temperature above the freezing point and evaporate any runback water film. Previous research has utilized numerical simulation analysis to predict the performance of electro-thermal anti-icing systems. The conjugate heat transfer method has been commonly employed to predict temperature distribution on the protected surface. However, non-isothermal surfaces exhibit distinct local convective heat transfer coefficients that influence local thermal balance, unlike isothermal surfaces that adopt the loosely-coupled method for computational efficiency. In this study, we present a novel target temperature-based anti-icing simulation method that predicts the required heat flux for thermal ice protection systems without employing the conjugate heat transfer method. Our objective was to calculate the necessary heat flux to achieve the desired non-isothermal surface temperature for effective anti-icing. By eliminating the excessive iteration process associated with the coupling method for conjugate heat transfer, we have streamlined the simulation procedure. Through validation, target temperature-based anti-icing simulation method, when compared to the tight coupling method, demonstrated the ability to predict the same surface water flow rates while reducing computation time by up to 90 %. Furthermore, when applied to design problems, our method achieved approximately a 10 % reduction in the required heat capacity for anti-icing compared to experimental values. As a result, target temperature-based anti-icing simulation method offers a more efficient alternative to traditional conjugate heat transfer methods, providing valuable insights for both predicting anti-icing system performance and optimizing aircraft design.

Computational simulation of aircraft electrothermal de-icing using an unsteady formulation of phase change and runback water in a unified framework

Unsteady simulation of aircraft electro-thermal deicing process with temperature-based method

In-flight anti-icing simulation of electrothermal ice protection systems with inhomogeneous thermal boundary condition

Numerical Simulation of an Electrothermal Ice Protection System in Anti-Icing and Deicing Mode

Validation of Unsteady Thermodynamic CFD Simulations of Aircraft Wing Anti- Icing Operation

Numerical procedure for electro-thermal anti-icing system simulation coupling internal thermal analysis and external multi-physic code

Unsteady numerical simulations of aircraft icing based on the dynamic grid method

Development of a Computational Fluid Dynamics Model for Ice Formation: Validation and Parameter Analysis

Peridynamic modeling and simulation of thermo-mechanical de-icing process with modified ice failure criterion

A New Ice Accretion Model for Aircraft Icing Based on Phase-Field Method

Target temperature-based simulation method for predicting performance and designing aircraft thermal anti-icing systems

Study on Loose-Coupling Methods for Aircraft Thermal Anti-Icing System

Study on thermodynamic coupling behavior of non-Newtonian deicing fluid droplets impinging on solid walls at low temperature

Numerical Simulation of Aircraft Icing under Local Thermal Protection State

Multi-physics simulation of in-flight ice shedding

Numerical Simulation of Water Film Flow and Breakup on Anti-Icing Surface

Electrothermal Ice Protection Systems De-Icing: An Experimentally Validated Idealized Ice Shedding Model

Study of Solidification and Microstructure Characteristics for Aircraft Icing

Numerical Simulation of Ice Crystal Supercooled Droplet Mixed Phase Icing Based on the Improved Messinger Model

2D Numerical Simulation of a Wind Turbine De-Icing System, Using Cycled Heating

Asymmetric Heat Transfer in Aircraft Electrothermal Anti-Icing