Abstract:The prevention of ice build-up on aircraft surfaces is crucial for safe operations. Thermal ice protection systems, particularly electro-thermal systems, are commonly employed to mitigate ice formation. However, the weight of electric batteries used in these systems significantly impacts aircraft performance, necessitating the minimization of power load during design. Despite this requirement, effective anti-icing operation mandates a sufficient heat flux to maintain surface temperature above the freezing point and evaporate any runback water film. Previous research has utilized numerical simulation analysis to predict the performance of electro-thermal anti-icing systems. The conjugate heat transfer method has been commonly employed to predict temperature distribution on the protected surface. However, non-isothermal surfaces exhibit distinct local convective heat transfer coefficients that influence local thermal balance, unlike isothermal surfaces that adopt the loosely-coupled method for computational efficiency. In this study, we present a novel target temperature-based anti-icing simulation method that predicts the required heat flux for thermal ice protection systems without employing the conjugate heat transfer method. Our objective was to calculate the necessary heat flux to achieve the desired non-isothermal surface temperature for effective anti-icing. By eliminating the excessive iteration process associated with the coupling method for conjugate heat transfer, we have streamlined the simulation procedure. Through validation, target temperature-based anti-icing simulation method, when compared to the tight coupling method, demonstrated the ability to predict the same surface water flow rates while reducing computation time by up to 90 %. Furthermore, when applied to design problems, our method achieved approximately a 10 % reduction in the required heat capacity for anti-icing compared to experimental values. As a result, target temperature-based anti-icing simulation method offers a more efficient alternative to traditional conjugate heat transfer methods, providing valuable insights for both predicting anti-icing system performance and optimizing aircraft design.

Numerical procedure for electro-thermal anti-icing system simulation coupling internal thermal analysis and external multi-physic code

Numerical Simulation of an Electrothermal Ice Protection System in Anti-Icing and Deicing Mode

In-flight anti-icing simulation of electrothermal ice protection systems with inhomogeneous thermal boundary condition

Computational simulation of aircraft electrothermal de-icing using an unsteady formulation of phase change and runback water in a unified framework

Experimental Validation and Tightly Coupled Numerical Simulation of Hot Air Anti-Icing System Based on an Extended Mass and Heat Transfer Model

Numerical Simulation of Aircraft Icing under Local Thermal Protection State

Target temperature-based simulation method for predicting performance and designing aircraft thermal anti-icing systems

NUMERICAL INVESTIGATION OF THE HEAT AND MASS TRANSFER ON ANTI-ICING SURFACE

Numerical Simulation Analysis of a Guide Vane Hot Air Anti-icing System

Study on Loose-Coupling Methods for Aircraft Thermal Anti-Icing System

Numerical Icing Simulations of Cylindrical Geometry and Comparisons to Flight Test Results

Numerical Simulation of Hot Air Anti-icing Charateristics of an Aero-engine Strut

A Three-Dimensional Fictitious Domain Method for Direct Numerical Simulations of Particle-Laden Flows with Heat Transfer

Unsteady simulation of aircraft electro-thermal deicing process with temperature-based method

Validation of Unsteady Thermodynamic CFD Simulations of Aircraft Wing Anti- Icing Operation

Asymmetric Heat Transfer in Aircraft Electrothermal Anti-Icing

Development of a 3D Eulerian/Lagrangian Aircraft Icing Simulation Solver Based on OpenFOAM

Calculation of the heat transfer and temperature on the aircraft anti-icing surface

A New Melting Model in Electrothermal De-Icing Simulation

Numerical Simulation Model of Electrothermal De-Icing Process on Composite Substrate

Numerical Analysis of Oil Anti-Icing System Performance of Turboshaft Engine Inlet Strut