Abstract:To investigate structural changes, the Cu95Fe5 alloy system was subjected to cooling rates of 1 × 1013 K/s, 2 × 1012 K/s, 2 × 1011 K/s, and 2 × 1010 K/s using the molecular dynamics simulation method. The results revealed that decreasing the cooling rate caused an increase in the phase transition temperature. Further, the structure of the alloy system exhibited a tendency towards increased stability following cooling at lower cooling rates. The Fe precipitation behavior of the Cu95Fe5 alloys during cooling at the rate of 2 × 1010 K/s was further explored, with the results suggesting that the formation and growth of the Fe cluster is a continuous process governed by the nucleation and growth mechanism. The size and number of Fe clusters formed at different stages were found to be affected by three factors, namely, the interaction force between the Fe atoms, the diffusion ability of the Fe atoms, and the interfacial energy between the Fe cluster and Cu matrix. When the alloy temperature exceeded 1400 K, the accumulation of the Fe atoms was facilitated by their strong interaction. However, the high temperatures and the large diffusion coefficient of the Fe atoms acted as inhibitors to the growth of Fe clusters, despite the intense thermal activities. As the temperature was reduced from 1400 K to 1050 K, the Fe atoms moved with a reduced intensity in a narrower area, and both the number of Fe atoms in the largest cluster and the number of clusters increased due to the action of the interaction force between the Fe atoms. Upon lowering the temperature from 1050 K to 887 K, the size of the largest Fe cluster increased rapidly, while the number of clusters decreased gradually. The growth of the largest Fe cluster could be partly attributed to the diffusion of single Fe atoms into the cluster under the action of the interaction force between the Fe atoms, in addition to the gathering and combination of multiple clusters. When the temperature was lowered from 967 K to 887 K, the diffusion coefficient of the Fe atoms approached 0, indicating that the non-diffusive local structure rearrangements of atoms dominated in the system structure change process. The interface energy governed the combination of the Fe clusters in this stage. At a temperature below 887 K, the alloy crystallized, the activities of the Fe atoms were reduced due to a low temperature, and the movement range of the Fe atoms was small at a fast cooling rate. As such, both the size and number of Fe clusters showed no obvious changes.

MOLECULAR DYNAMICS SIMULATION OF MICROSTRUCTURAL CHANGE OF Cu0.6Ni0.2Fe0.2 ALLOY DURING THE COOLING PROCESS

MOLECULAR DYNAMICS SIMULATIONS OF STRUCTURAL PROPERTIES OF CuNi ALLOYS DURING THE COOLING PROCESS AT HIGH PRESSURE

INFLUENCE OF PRESSURE AND ATOMIC CONCENTRATION ON STRUCTURE AND MECHANICAL PROPERTIES OF CuNi ALLOY BY MOLECULAR DYNAMICS SIMULATION

Multi-component Phase-Field Simulation of Microstructural Evolution and Elemental Distribution in Fe–Cu–Mn–Ni–Al Alloy

Inversion calculation of the interatomic potentials for Ni0.75AlxMo0.25-x alloy employing microscopic phase-field model

Molecular Dynamics Research on Fe Precipitation Behavior of Cu95Fe5 Alloys during Rapid Cooling

Effect of Minor Addition of Co on Nonequilibrium Solidification of Deeply Undercooled Cu Based Alloys

Microstructure evolution of super-cooled Cu-Ni-Fe alloy

Simulation Study of the Effets of Various Cooling Rates on Evolution Properties of Micro-Cluster Structure During Solidification Processes of Liquid Metal Cu

Molecular Dynamics Study on the Crystallization Process of Cubic Cu–Au Alloy

Co effect on rapid solidification microstructure transition of highly undercooled copper alloys

On the Evolution of Nano-Structures at the Al–Cu Interface and the Influence of Annealing Temperature on the Interfacial Strength

Evolution Mechanism of Rapid Solidification Microstructure of an Undercooled Copper-Based Single Phase Alloy

Critical Cooling Rate and Microstructure Evolution of Cu-Based Bulk Amorphous Alloy

The Development of Microstructure of Ni 3 Al During Rapid Cooling and Heating

Specific Heat Determination and Simulation of Metastable Ternary Ni80Cu10Si10 Alloy Melt

Molecular Dynamics Simulation of a Core−Shell Structured Metallic Nanoparticle

Investigation of alloying process of Cu and Au nanoparticles based on molecular dynamics simulation

Structural Change of Ni–Cu Alloy Nanowires with Temperature Studied by in Situ X-ray Absorption Fine Structure Technique

Microstructure Evolution and Hot Deformation Behavior of a CuNiSn Alloy

Investigation on nonequilibrium crystallization of highly undercooled Cu–Ni–Co alloys