Effects of molding water content and compaction degree on the microstructure and permeability of compacted loess

Ping Li,Zhenhui Pan,Tao Xiao,Jiading Wang

DOI: https://doi.org/10.1007/s11440-022-01592-8

2022-07-28

Acta Geotechnica

Abstract:Molding water content and compaction degree are the major factors driving differences in the microstructure, which has a control on the permeability of compacted loess. Although the effect of compaction degree on the microstructure and mechanical characteristics of compacted loess has been well studied, the effect of molding water content has been rarely reported. In addition, the saturated permeability coefficient (SPC) is variable, which is often ignored and the variation of SPC during infiltration remains unclear. To address these problems, compacted loess samples with different molding water contents or compaction degrees were prepared, and their pore-size distribution curves (PSDs) and SPCs were determined using the mercury intrusion porosimetry (MIP) and variable head methods. In each permeability test, the seepage was repeated until the SPC was basically unchanged. So, the variation of SPC during infiltration could be obtained. In addition, the PSDs of some samples after the permeability tests were measured. The results show that the pore-size distributions of small pores (150 nm < d ≤ 2000 nm) and mesopores (2000 nm < d ≤ 12,000 nm) are mainly affected by molding water content, while compaction degree only changes the density of mesopores in compacted loess. Mesopores are considered as a group of pores controlling the SPC of compacted loess. The SPC variation is controlled by the structural local failure at low compaction degrees, while it is controlled by the loss of fine particles at high compaction degrees. In the end, the change of the PSD shape with molding water content, which could be related to the high sand content of the test material, was discussed. These findings are helpful for the design and construction of artificial loess slopes and foundations and can provide experimental evidence for the engineering performance modeling of compacted loess slopes and foundations due to inundation.

engineering, geological