Simulation Analysis on Ferroelectric Tunneling Layer VTFET with Different Dielectric Constant for Linear and RF/Analog Parameters

Shailendra Singh
DOI: https://doi.org/10.1007/s12633-022-01923-0
IF: 3.4
2022-05-17
Silicon
Abstract:This work introduces a new ferro material embedded structure between the tunneling junction to gain and increase the ON/OFF current ratio with a steeper subthreshold slope. To analyze and validate the device appropriate for low power digital and analogue applications, several linear and RF/analog device characteristics were used. The primary goal is to investigate the effect of ferroelectric layer at tunneling junction of VTFET on Id-Vgs characteristics and compare it to the performance for different dielectric constant values using TCAD simulation Silvaco software. SiO2−FTJ-VTFET, HfO2-FTJ-VTFET and GS-FTJ-VTFET are the three-configuration proposed with the highest reported ON current and ON/OFF current ratio are 1.72 × 10−4 (A/μm) and 2.02 × 1013 respectively. The device’s geometrical scaling will be improved by the vertical layout of the source channel and drain. With respect to the ferroelectric layer at the tunneling junction, RF/analog parameters such as transconductance (gm), output conductance (gd), gate capacitance (Cg), and linear features such as second and third derivative of transconductance gm2, gm3, VIP2 and VIP3 have been examined for given configurations. Form the given graph one can validate the comparison done on the basis of different dielectric used among which the gate-staked based GS-FTJ-VTFET configuration will shows the optimized results due to mitigation of lattice mismatch issue with enhance controllability of gate over the device channel. Based on its performance, the device was found to be suitable for low-power applications. TFP and GFP are commonly employed in low RF/analog applications due to their enhanced gain for low gate voltage biasing.
materials science, multidisciplinary,chemistry, physical
What problem does this paper attempt to address?