Abstract:Automatic impact modal testing is a technique gaining momentum in recent years thanks to the popularization of Scanning Laser Doppler Vibrometry. These systems allow automatizing the output measurement of thousands of degrees of freedom in a short time. The use of automatic impact modal hammers allows automatizing the excitation input and broadband excitation without loading a structure with an extra mass or other drawbacks. However, the impact force repeatability is a prominent concern among test engineers, especially those who work with materials with non-proportional force/response ratios. Assessing the impact force repeatability of a given automatic modal hammer or test rig is necessary in order to ensure the right response level is measured impact after impact.The assessment procedure can be misleading if not done right. Studying the automatic modal hammer repeatability under typical modal test conditions invariably leads to impact signals strongly distorted by the so called picket fence effect. This results in impacts sampled by only 3–4 data points; insufficient to accurately describe the actual impact force signals and the short contact times between hammer tip and structure. In the reality, the impacts are of larger magnitudes and shorter contact times than what is shown by the analyzer in typical test conditions.This work studies the influence of the sampling frequency and the test structures used on the repeatability assessment of automatic impact modal hammers. Impact force signals are acquired in this work with enough resolution to eliminate the picket fence effect and truly evaluate how repeatable and reproducible automatic impacts are. The practicality of the procedure, which involves very large datasets and long testing times, is discussed. Guidelines are offered at the end of the paper for a successful repeatability and reproducibility assessment of automatic impact modal hammers.

Modal testing on a limited budget: Analysis of instrumented hammer alternatives for impact testing

An Open-Source, Scalable, Low-Cost Automatic Modal Hammer for Studying Nonlinear Dynamical Systems

Across the Picket Fence: Influence of Sampling Frequency in Automatic Impact Modal Testing

Multiple Impact Phenomenon in Impact Hammer Testing: Theoretical Analysis and Numerical Simulation

A Fast Automated Impact Hammer Test Method for Modal Parameter Extraction: Implementation on a Composite Bridge Beam

Development of Structural Testing Equipment for Impact and Complex Loading

Experimental Modal Analysis of Horizontal Machine Tools

Semi-automated impact device based on human behaviour recognition model for in-service modal analysis

Experimental and computational evaluation of modal identification techniques for structural damping estimation

Structural Damage Identification using Modal Data. II: Test Verification

Modal Test and Analysis of Electronic Cabinet

Forty Years of Use and Abuse of Impact Testing: A Practical Guide to Making Good FRF Measurements

Hammer'S Impact Force on Pile and Pile'S Penetration

Damage Assessment of Structures Using Modal Test Data

Input force and floor impedance measurement for the standard tapping machine and the standard impact ball

Evolution of modal characteristics of a mid‐rise cold‐formed steel building during construction and earthquake testing

Output-only modal testing and monitoring of civil engineering structures: instrumentation and test management

A dynamic modal testing technique for noninvasive assessment of bone-dental implant interfaces

Modal characterization of a three‐story buckling‐restrained braced frame steel building by non‐destructive field testing

High-resolution modal analysis

Operational Modal Analysis, Testing and Modelling of Prefabricated Steel Modules with Different LSF Composite Walls