Abstract:The growing need for sustainable and low-carbon energy sources has led to significant research in alternative fuels. The majority of energy produced today comes from fossil fuels, which has led to enormous emissions of greenhouse gases. The direct combustion of fossil fuels produces syngas and hydrogen, which contribute to global warming. In contrast, the gasification process of biomass produces clean energy in the form of syngas and hydrogen. The biomass and plastic co-gasification has gained a lot of attention recently due to the challenges associated with gasifying biomass and plastic wastes separately. The broader objectives of this study are to alleviate these waste management problems and optimize the syngas LHV and H 2 content using co-gasification process. The synthesis gas is a crucial intermediary used to create chemicals and fuels for transportation. The hydrogen component of synthesis gas can also be utilized directly as fuel for hydrogen fuel cells, which produce electricity. This work employs Aspen simulator to analyze an optimum processing condition where the synthesis gas has the maximum feasible hydrogen content and calorific value which has not been investigated in the available literature so far. Aspen software is used in this study since it can be useful in figuring out reaction yield and performing parametric studies to optimize process conditions. It is found that the carbon dioxide emission sharply decreases as the proportion of plastic increases in co-gasification. The mole fractions of CO, H 2 and CO 2 that the current model predicts using experimental data on rice husk have average modeling errors of less than 8%, indicating a satisfactory fit with the experimental findings. Under 1 bar of pressure and a combined feed rate of 100 kg/h for both plastic and biomass, the simulation was run at temperatures between 550 °C and 1300 °C. When steam was added, the fraction of hydrogen increased by approximately a factor of two for a steam-to-biomass ratio (SBR) of 2. Following the addition of plastic to the feed, the amount of hydrogen in the produced gas rose for all temperatures. When 15% plastic is combined with the feed at 850 °C, carbon dioxide is reduced by roughly 60%. The results indicate significant increase in calorific value of the product as well as the hydrogen proportion—suggesting plastic addition as an excellent method to improve the LHV of biomass gasification.

Co-gasification of rice husk and plastic in the presence of CaO using a novel ANN model-incorporated Aspen plus simulation

Simulation of biomass-plastic co-gasification in a fluidized bed reactor using Aspen plus

Multiscale Modeling of Plastic Pyrolysis with a Neural Network-Inspired Pyrolysis Kinetic Model and Coarse-Grained DEM-CFD

Syngas and hydrogen production from co-gasification of rice husk biomass and plastic waste mixture using Aspen Plus

Modelling of Biomass Gasification Through Quasi-Equilibrium Process Simulation and Artificial Neural Networks

Simulation of Rice Straw Oxygen-Steam Gasification in an Entrained-Flow Gasifier Using ASPEN PLUS

Gasification of biomass using oxygen-enriched air as gasification agent: a simulation study

Co-gasification of biomass and polyethylene: a simulation study by considering tar formation

Integrated neural network and aspen plus model for entrained flow gasification kinetics investigation

Numerical investigation of sugarcane bagasse gasification using Aspen Plus and response surface methodology

Artificial neural network model of co-gasification of petroleum coke with coal or biomass in bubbling fluidized bed

Energy, efficiency, and environmental analysis of hydrogen generation via plasma co-gasification of biomass and plastics based on parameter simulation using Aspen plus

Co-gasification of rural solid waste and biomass in rural areas: Simulation and plant-scale process

Simulation and modeling of hydrogen production and power from wheat straw biomass at supercritical condition through Aspen Plus and ANN approaches

Integrated process for simulation of gasification and chemical looping hydrogen production using Artificial Neural Network and machine learning validation

Simulation of air gasification of Napier grass using Aspen Plus

Thermodynamics, kinetics, gas emissions and artificial neural network modeling of co-pyrolysis of sewage sludge and peanut shell

Gasification Characteristics of MSW and an ANN Prediction Model

Investigation on Synergism and Its Influence Parameters between Coal and Biomass during Co-Gasification Based on Aspen Plus

Simulation of Coal Char Gasification Using O 2 /CO 2

Prediction of gas‐liquid‐solid product distribution after solid waste pyrolysis process based on artificial neural network model