INVESTIGATION OF OSCILLATING ROLLER OPERATING MODES

E. A. Shishkin,Z. S. Kravtsov

DOI: https://doi.org/10.14489/hb.2022.06.pp.024-030

2022-06-01

Abstract:The rigidity of the compacted material, the amplitude and frequency of the vibration exciter, the operating speed affect the operating mode of the oscillating roller. The following operating modes are distinguished: clutch, one-way slip, asymmetric slip, symmetrical slip. The latter mode is undesirable and should be avoided in the practice of using oscillatory rollers. The objective of the study is to establish the indicator of the transition of the oscillatory roller to the symmetrical sliding mode. In this paper, simulation modeling of the oscillatory motion of an oscillatory roller using the fast Fourier transform functional is carried out. As a result of modeling, it was found that as the operating mode of the roller approaches the symmetrical sliding mode, the amplitudes of even frequency components 2f, 4f, etc. tend to zero in the spectrum of the curve of the horizontal acceleration of the roller. As a condition for the inefficiency of the oscillating roller, it is accepted that the ratio of the amplitudes of the frequency components A2f /Af reaches a certain value of Asim, which depends on the physical and mechanical characteristics of the compacted material, and is determined experimentally. The results of the study can be used in the design of an intelligent control system for an oscillating roller.