Abstract:Boring trepanning association (BTA) deep hole drilling is one of the most important manufacturing techniques to produce a large length-to-diameter ratio hole for industrial applications. In addressing the challenge of excessive surface damage, inefficiency and poor indexing in BTA deep hole drilling, for which there are limited studies reported. The functional behaviour of deep hole machining and the correlation between the machined surface quality, subsurface layer deformation and the machining conditions are investigated in this paper, together with the drilling mechanism. Various parameter combinations are used to produce different samples on which surface roughness and microstructures are studied. Metallurgical characterization is performed on the subsurface regions, followed by qualitative and quantitative mechanical nanohardness investigations. Electron microscopic analysis reveals various surface features such as grooves and plateaus, folding, material flaking that are exclusive to deep hole drilling. It has been found that improved surface integrity in BTA drilling relies on a trade-off among feedrates and speeds. Although considered sample dependent, combination of a feedrate of 28 mm min(-1) and a speed of 630 r min(-1) can produce nearly excellent surface integrity. Grain structure observations over the subsurface reveal three different layered zones including an ultrafine grain structure layer, a transitional grain structure layer and a substrate material layer. A significantly hardened (56% increase) surface layer on cutting-and-burnishing region comparing with the solely cutting region is detected. The subsurface grain features are induced by repeated thermo-mechanical functioning that causes grain refinement and thus materials hardening. The different surface integrities are the result of comprehensive functions of the machining parameters and combined drilling mechanism.

Optimizing the cutting edge geometry of micro drill based on the entropy weight method

A Multiscale Evaluation of the Surface Integrity in Boring Trepanning Association Deep Hole Drilling

Analysis of the Chip-Splitting Performance of a Dedicated Cutting Tool in Dry Orbital Drilling Process

Modeling of Non-Linear Cutting Forces for Dry Orbital Drilling Process Based on Undeformed Chip Geometry

Cutting Performance Optimization and Experimental Research of Indexable Insert Drill

Suppressing the burr of high aspect ratio structure by optimizing the cutting parameters in the micro-milling process

A review on the balancing design of micro drills

The micro-drilling process fine modeling with the strain characteristics of undeformed chip considered

Development of a New Micro Drilling Tool with H-Shaped Chisel Edge

Multi-objective optimization of machining parameters in micro-milling LF 21 based on the AHP-entropy weight method

Optimized design of indexable insert drill based on radial cutting force balance

Evaluation of different tool geometries in the finite element simulation of ultrasonic-assisted drilling of Ti6A14V

An Analysis and Optimization of the Geometrical Inaccuracy in WEDM Rough Corner Cutting

Analysis and optimization of cutter geometric parameters for surface integrity in milling titanium alloy using a modified grey–Taguchi method

Enhancing Wear Resistance and Cutting Performance of a Long-Life Micro-Groove Tool in Turning AISI 201

Design method and parameter optimization of small angle rake face of hourglass worm gear hob

Comprehensive Evaluation Analysis and Optimization Methodology of Tool Geometric Parameters for High Speed Cutting

Micro-milling force modeling with tool wear and runout effect by spatial analytic geometry

Experimental Study on Chip Shape and Tool Wear of High-Speed and Micro-Feed Cutting

Experimental Study on the Minimum Undeformed Chip Thickness Based on Effective Rake Angle in Micro Milling

Investigation on Cutting Performance of Micro-Textured Cutting Tools