Abstract:Safe drinking water requires sound monitoring and maintenance of residual chlorine within drinking water distribution networks (DWDNs) to suppress possible microbial regrowth. However, in the developing world, DWDNs face unique challenges, including aging infrastructure, water pipes laid near or even aboveground thus exposing water to high temperature fluctuations, and relatively high organic loads. Therefore, safely maintaining sustainable residual chlorine levels and restricting the problems of hazardous disinfection by-products (DBPs) formation and of antimicrobial resistance (AMR), both tracing back to extensive chlorination, is a difficult exercise in those settings. Here, the temperature dependent bulk chlorine decay, i.e., the rate at which chlorine residual is consumed, was estimated for a typical DWDN system in South Africa. To this end, experimental assays were performed and a mathematical model was developed to predict chlorine levels within the DWDN under study. A direct relationship (R2 = 0.99) between bulk chlorine decay and initial chlorine dosage was identified, with bulk chlorine decay following the first-order decay model. The bulk chlorine decay rate coefficient (Kb) and the reaction constant with the pipe walls (Kw) were experimentally estimated, with the first being the main chlorine consumer and the latter only slightly contributing to chlorine decay. EPANET was used to simulate the chlorine concentrations within the examined DWDN, while residual chlorine concentrations were modelled using COMSOL. The software programs were calibrated and validated using experimental results. The optimum liquid chlorine dosage was 5 mg L-1, and this could maintain residual levels at 0.5 mg L-1 for 3500 min in the water distribution tanks. Yet, the residual chlorine levels at the distal end of the DWDN were below the recommended safety limits, suggesting the need for chlorine booster stations to supplement residual chlorine rather than further increasing chlorine initial dosages which will lead to unsafe chlorine levels at the proximal points and inevitably will increase DBPs in drinking water. This relatively high chlorine dosage reflects the overall poor quality of the raw water that feeds the drinking water treatment plant under study, which is consistent with the poor water quality of surface water in South Africa. Overall, this methodology can be replicated in DWDNs in South Africa and across the developing world, where similar challenges persist and ensure safe drinking water but not at the expense of DBPs formation and possibly AMR spreading.

Modeling of Residual Chlorine on Addis Ababa Water Supply Distribution Systems

Desalinated Seawater into Pilot-Scale Drinking Water Distribution System: Chlorine Decay and Trihalomethanes Formation

Chlorine Decay and Trihalomethanes Formation in Water Distribution System

Joint Majorization of Waterworks and Secondary Chlorination Points Considering the Chloric Odor and Economic Investment in the DWDS Using Machine Learning and Optimization Algorithms.

Multi-objective Optimization of Water Quality Performance Considering THM in Water Distribution Systems

Second-order Chlorine Decay and Trihalomethanes Formation in a Pilot-Scale Water Distribution Systems.

Optimal Operation of Residual Chlorine Concentration in Multi-Source Water Distribution System

Chlorine wall decay coefficients calibration of water distribution quality model

Chlorine Decay in Water Supply Pipelines: Impact of Nitrogen Concentration in the Source Waters

Optimal scheduling and analysis of booster chlorination in water distribution network based on desired chlorine residual mass concentration

Chlorine decay and THMs formation models based on pilot-scale water distribution system

Modeling Chlorine Residuals In Urban Water Distribution Networks (Al-Ashrafieh – Homs)

Experimental appraisal and numerical modelling of chlorine demand and decay in a typical drinking water distribution network in South Africa

A Novel Statistical Model for Water Age Estimation in Water Distribution Networks

Optimizing the number, locations, and chlorine dosages of booster chlorination stations in water distribution networks

Trihalomethanes and physicochemical quality of drinking water in Addis Ababa, Ethiopia

Climate change and future water demand: Implications for chlorine and trihalomethanes management in water distribution systems

Water quality analysis of municipality public water supply in the case of Asella town at the source of Ashebeka River, a cross-sectional study design.

Optimization and Assessment of Residual Chlorine using Response Surface Methodology (RSM) and Artificial Neural Network (ANN) Modeling

Evaluation of drinking water quality and associated health risks in Adama City, Ethiopia

Calibration of water quality model for distribution networks using genetic algorithm, particle swarm optimization, and hybrid methods