Abstract:A detailed assessment of the thermo-mechanical limits of the ITER divertor with respect to potential excessive local transient heat loads due to Edge Localised Modes (ELMs) has revealed a particular power loading scenario arising from the fact that ELM ions expelled from the upstream pedestal region will arrive at the divertor target plates without substantial thermalisation. As a consequence of their Larmor gyration around magnetic field lines, they are able to penetrate toroidal gaps between individual monoblocks of the target plate structure and can deliver rather intense heat loads to monoblock side faces near the gap entrance. To verify that this ELM-induced loading, predicted by both ion orbit simulations and particle in cell simulations, really does occur, two dedicated experiments have been performed on the ASDEX Upgrade tokamak. In both experiments a model toroidal gap structure of similar dimensions to those of the ITER divertor target monoblocks was exposed to a series of identical H-mode discharges with strong type-I ELMs. The effects arising from the gyro motion of hot ELM ions were identified by inverting, in the second experiment, the directions of both toroidal field and plasma current, thus reversing the ion gyration direction. The local distribution of incident ion flux on the gap side faces was quantified by pre- and post-exposure analysis of platinum marker layers to determine quantitatively the erosion rate of the platinum marker. The results fully confirm the ion orbit code predictions with respect to the penetration depth of incident ions with gyro orbits of similar or larger radius than the gap width. Moreover, the results confirm that ELM ions do indeed arrive at the divertor with their typical pedestal energies and also allow conclusions to be drawn regarding the corresponding intra-ELM ion particle and power flux, which is not easy to quantify using Langmuir probes.

Effects from the Target Plate Geometry on Fluctuations of Helium Plasma in the Linear Divertor Simulator Magnum-PSI

Microwave Diagnostics System in the HL-2A Tokamak

Plasma behaviour with hydrogen supersonic molecular beam and cluster jet injection in the HL-2A tokamak

Experimental and simulation study of argon helicon discharge in the linear plasma device MPS-LD

Multi-physics modeling of the long-term evolution of helium plasma exposed surfaces

Effect of detachment on Magnum-PSI ELM-like pulses: Direct observations and qualitative results

Effect of detachment on Magnum-PSI ELM-like pulses: I. Direct observations and qualitative results

Analysis of Divertor Heat Flux with Infrared Thermography During Gas Fuelling in the Hl-2a Tokamak

Numerical Studies for Plasmas of a Linear Plasma Device HIT-PSI with Geometry Modified SOLPS-ITER

Experimental Investigation on High Heat Flux Plasma Parameters of HIT-PSI Device in Argon Discharges

Statistical analysis of magnetic divertor configuration influence on H-mode transitions

Investigation of ELM-related Larmor ion flux into toroidal gaps of divertor target plates

Modifications of Tungsten lrradiated by Low Energy and High Flux Helium Plasma

Dependence of divertor turbulence on plasma density and current in TCV

Self-consistent multi-component simulation of plasma turbulence and neutrals in detached conditions

Shear Alfvén Fluctuation Spectrum in Divertor Tokamak Test Facility Plasmas

Structure and Dynamics of Magneto-Inertial, Differentially Rotating Laboratory Plasmas

Plasma-Parameter Dependence of Ro-Vibrational Temperatures for $\mathrm{H}_2$ in LHD Divertor

Effects of Divertor Electrical Drifts on Particle Distribution and Detachment Near the Divertor Target Plate in DIII-D

Experimental Study of Turbulence and Zonal Flow in Edge Plasmas of the HL-2A Tokamak

New millimeter-wave diagnostics to locally probe internal density and magnetic field fluctuations in National Spherical Torus Experiment-Upgrade (invited)