Abstract:A two-temperature magnetohydrodynamic (MHD) model, which evolves the electron and ion temperatures separately, is implemented in the PSI-Tet code and used to model plasma dynamics in the HIT-SI experiment. When compared with single-temperature Hall-MHD, the two-temperature Hall-MHD model demonstrates improved qualitative agreement with experimental measurements, including: far-infrared interferometry, ion Doppler spectroscopy, Thomson scattering, and magnetic probe measurements. The two-temperature model is utilized for HIT-SI simulations in both the PSI-Tet and NIMROD codes at a number of different injector frequencies in the 14.5-68.5 kHz range. At all frequencies the two-temperature models result in increased toroidal current, lower chord-averaged density, and symmetrization of the current centroid, relative to single-temperature simulations. Both codes produce higher average temperatures and toroidal currents as the injector frequency is increased. Power balance and heat fluxes to the wall are calculated for the two-temperature PSI-Tet model and indicate considerable viscous and compressive heating, particularly at high injector frequency. Parameter scans are also presented for the artificial diffusivity, and Dirichlet wall temperature and density. Artificial diffusivity and the density boundary condition both significantly modify the plasma density profiles, leading to larger average temperatures, higher toroidal current, and increased relative density fluctuations at low diffusivity and low wall density. High power, low density simulations at 14.5 kHz achieve sufficiently high gain (G = 5) to generate significant volumes of closed flux lasting 1-2 injector periods.

Numerical Studies for Plasmas of a Linear Plasma Device HIT-PSI with Geometry Modified SOLPS-ITER

Conceptual Design of a Compact Divertor Heat Load Simulation Device: HIT-PSI

Experimental Investigation on High Heat Flux Plasma Parameters of HIT-PSI Device in Argon Discharges

Research on the Characteristics of the Helium Plasma Beam in HIT-PSI

1 EX / P 3-21 Plasma Behavior with Hydrogen Supersonic Molecular Beam and Cluster Jet Injection in the HL-2 A Tokamak

Simserver Simulation of a Model-Based Current Profile Controller in the DIII-D Plasma Control System

Multi-physics modeling of the long-term evolution of helium plasma exposed surfaces

Development and Optimization of Step-A Linear Plasma Device for Plasma-Material Interaction Studies

Numerical Simulation of Heat Transfer and Fluid Flow of a Non-Equilibrium Argon Plasma Jet with Confined Wall

Numerical simulation of a helium Plasma-Material Interaction experiment in GyM linear device through SOLPS-ITER and ERO2.0 codes

Advanced modeling for the HIT-SI Experiment

Numerical Research on Plasma Generation and Expansion into Vacuum

Plasma-surface interaction studies in the HL-1 tokamak

Experimental and simulation study of argon helicon discharge in the linear plasma device MPS-LD

Numerical study of the interaction of a helium atmospheric pressure plasma jet with a dielectric material

Plasma initiation and preliminary magnetic control in the HL-2M tokamak

Particle-based simulation of atom and ion transport in HiPIMS: effect of the plasma potential distribution on the ionized flux fraction

Numerical Simulation of Plasma Plume with an Insulated Wall in Sheath Region Using a DSMC-PIC Parallel Algorithm

Numerical Study of Supersonic Plasma Torch

Fully kinetic study of facility pressure effects on RF-source magnetic nozzles

Effects from the Target Plate Geometry on Fluctuations of Helium Plasma in the Linear Divertor Simulator Magnum-PSI