Abstract:PurposeTrack irregularities contribute a large impact on the vibrations of a railcar. Therefore, this research is about assessing the impact of track irregularities on the rail vehicle vibration in the case of Addis Ababa Light Rail Transit Service. To assure the comfort of passengers in the railcar, it is important to monitor and identify rail irregularities that lead to rail-car uncomfortable vibrations. The objective of this research is to establish a method that uses rail irregularity measurement data and railcar design parameters to determine the railcar vibrations levels and frequency spectrum.MethodTo achieve the objective, the analytical vibration equations of the half-railcar model with twelve degrees of freedom were derived and solved using MATLAB. The impact of periodic track irregularities on a bogie's primary rubber-made suspension materials was also analyzed in MATLAB. On the other hand, a 3D bogie lumped model with the railcar mass via secondary suspension and with Hertzian contact effects neglected in finite element model was analyzed to validate the analytical modal equations. The natural frequencies provided by 3D Finite Element Method (FEM) with full dimensions are compared with those obtained using lumped parameter model analytically.ResultsThe frequency of the car-body that corresponds to bounce motion provided by lumped parameter model was 14.89Hz, while the frequency obtained from modal analysis by FEM was 13.829Hz. Then, conformity of the frequencies in both models provided confidence in the correctness of the analytical model. The displacement of the railcar found was low and cannot cause fatigue to the vehicle components.ConclusionAs the significance of this research, rail irregularities that lead to a car-body vibration frequency spectrum that produces an uncomfortable ride can be carefully investigated to eliminate their effect, with reference to ISO 2631, which defines the methods for measuring human vibration levels and their effects on comfort. Their effect must be eliminated in the railway lines by either correcting the track or using appropriate railcar suspension parameters.

Vibration Responses of the Railcar Under Rail Irregularities: Case of Addis Ababa Light Rail Transit

Study of Ground Vibration from Trains Caused by Track Irregularities

Effect of Rail Rigidity on Track-Ground Vibration Due to a High-Speed Train

Track Irregularities Estimation Based on the Vibration of Car-Body

Track Irregularity Assessment in High-Speed Rail by Incorporating Carriage-Body Acceleration with Transfer Function

Ground Vibration Caused by Axle Load and Dynamic Wheel-Rail Force of a Moving Train

Modeling of railway track integrating a shock-absorbing mat at the sleepers-ballast interface using eigenfunctions of displacement

Track Irregularities Estimation Based on Acceleration Measurements

Coupling effect of track irregularity and wheel–rail contact conicity on carbody swaying of a metro vehicle: an experimental investigation

Analysis of the influence of track irregularity on high-speed train ride comfort

Research on the Track Structure Vibration Induced by Subway Train

Track and ground vibrations generated by high-speed train running on ballastless railway with excitation of vertical track irregularities

Analysis And Evaluation Of Ground Vibration Response Induced By Rapid Rail Transit

Measurement and Analysis of Vibration Levels in Rail Transport in Central Europe

Seismic-Induced Geometric Irregularity of Rail Alignment under Transverse Random Earthquake

Characteristics and control limit of wheel-rail high-frequency vibrations induced by periodic short-wave irregularities under higher operating speed

Correlation of Short Pitch Rail Corrugation with Railway Wheel-Track Resonance at Low Frequencies of Excitation

Carbody abnormal lateral vibration failure of high–speed train induced by the coupling factor of the wheel re–profiling method and excessive rail wear

Experimental Study of Wheel-to-Rail Interaction Using Acceleration Sensors for Continuous Rail Transport Comfort Evaluation

Experimental and Numerical Investigation on Multi-module Coupling Vibration Performance of Light Rail Vehicle