Abstract:By using the transient finite element method, a three-dimensional wheelset-track coupled rolling contact model for high-speed rail is established, and the rationality and effectiveness of the model are verified by field measurements. Next, the wheel-rail contact stress states and relative slip characteristics are calculated and analyzed to reveal the cause of inner rail corrugation. Then, the vertical vibration acceleration of the rail/wheel is taken as the output variable to study the dynamic responses of the wheelset-track system. Finally, the parameter sensitivity analysis is carried out. The results show that the maximum normal/tangential contact stress between the inner wheel and inner rail is greater than that between outer wheel and outer rail due to the unbalanced load of inner rail caused by the excess superelevation of track structure, which indicates that the unbalanced load of the inner rail may aggravate the development of rail wear, and the rationality of the model established in this paper is verified. The wheel-rail relative slip region on the inner rail side appears periodically, and the distance between the two adjacent slip regions is close to the characteristic wavelength of the measured inner rail corrugation, which illustrates that the periodic variation of slip regions on the inner rail surface plays an important role in the formation of rail corrugation, and the validity of the model is verified. The periodic distribution of wheel-rail relative slip regions on the outer rail surface is not obvious, demonstrating that the outer rail tends to form uniform wear, which is consistent with the fact that the outer rail corrugation is slight in the measured section. The wheelset-track system has been in the process of unstable continuous oscillation in the analysis interval, combined with the analysis results of the wheel-rail relative slip characteristics, it can be concluded that the unstable self-excited vibration of wheelset-track system under the condition of tangential contact force reaching saturation is the main cause of rail corrugation. The dominant characteristic frequencies of vertical vibration accelerations of rail and wheel are all 561 Hz, the corresponding characteristic wavelength (148 mm) is close to the distance (150 mm) between the calculated adjacent slip regions, and is also close to the characteristic wavelengths (125 mm and 160 mm) of inner rail corrugation, which shows that the resonance phenomenon occurs in the wheelset-track system at the above frequency, thus leading to the increase of dynamic responses of wheelset-track system. The fastener vertical stiffness and wheel-rail coefficient of friction have significant effect on the development of rail corrugation, and the running speed determines the occurrence probability of inner/outer rail corrugation by affecting the track superelevation state.

Characteristics and control limit of wheel-rail high-frequency vibrations induced by periodic short-wave irregularities under higher operating speed

Track and ground vibrations generated by high-speed train running on ballastless railway with excitation of vertical track irregularities

Study of Ground Vibration from Trains Caused by Track Irregularities

Vertical vibration characteristics of wheelset-gearbox-bogie frame system in different track irregularity conditions: simulation and full-scale test

Effect of Rail Rigidity on Track-Ground Vibration Due to a High-Speed Train

Ground Vibration Caused by Axle Load and Dynamic Wheel-Rail Force of a Moving Train

Analysis of Rail Corrugation Characteristics on High-Speed Rail Based on Transient Finite Element Method

Study on the phenomenon of rail corrugation on high-speed rail based on the friction-induced vibration and feedback vibration

Full-scale test and numerical simulation of wheelset-gear box vibration excited by wheel polygon wear and track irregularity

Effect of Track Irregularity Amplitude on Dynamic Performance of Vehicle System under High-speed Operation

Dynamic effect and safety limits of rail weld irregularity on high-speed railways

Carbody abnormal lateral vibration failure of high–speed train induced by the coupling factor of the wheel re–profiling method and excessive rail wear

Effects of the Dynamic Wheel–rail Interaction on the Ground Vibration Generated by a Moving Train

Effect of operating conditions on the time-frequency characteristic of high-speed vehicle-turnout dynamic interaction using synchrosqueezed wavelet transform

The vibration behavior of railway track at high frequencies under multiple preloads and wheel interactions

Dynamic characteristics of wheel–rail collision vibration for high-speed train under crosswind

The stochastic characteristics of wideband-wavelength track irregularity on Chinese HSRs and its application to dynamic wheel–rail interaction

Mechanism of high-speed train carbody shaking due to degradation of wheel-rail contact geometry

Wave interference in railway track due to multiple wheels

Influence of high-frequency vibrations on the wheel-rail creep curve at high speeds

Vibration Characteristics of Defective Axle Box Bearings in High-Speed Trains under Track Irregularity Excitation