Abstract:Prediction of micropollutant abatements by catalytic ozonation is critical for its process design and optimization in water treatment. In this study, a chemical kinetic model based on ozone (O3) and hydroxyl radical (OH) rate constants (kO3 and kOH) and O3 and OH exposures is proposed for the generalized prediction of micropollutant abatement by homogeneous catalytic ozonation. Several micropollutants with kO3 ranging from <0.15 to 1.0 × 106 M−1 s−1 were spiked in water matrices (deionized water and surface water) and then treated by ozonation alone and homogeneous catalytic ozonation with varying transition metals (Ti2+, Co2+, Ni2+, Zn2+, Cu2+, Mn2+, Fe2+, and Fe3+). The addition of the varying catalysts enhanced the kinetics and yield of OH formation from O3 decomposition to different extent. Consequently, for the same applied O3 doses, higher OH exposures can generally be obtained at the expense of lower O3 exposures during catalytic ozonation with the varying catalysts compared to ozonation alone. The changes in O3 and OH exposures did not considerably influence the abatement of micropollutants with high and moderate O3 reactivities (diclofenac, gemfibrozil, and bezafibrate), whose abatement efficiencies were generally >90% during both ozonation alone and catalytic ozonation with the varying catalysts. In contrast, ozone-resistant micropollutants (2,4-dichlorophenoxyacetic acid, clofibric acid, and ibuprofen) were less effectively abated during ozonation (∼40–60% abatement), and the addition of the varying catalysts could enhance their absolute abatement efficiencies to various extent (∼0–10% in the deionized water and ∼0–22% in the surface water) during catalytic ozonation. Despite the differing catalytic mechanisms of the varying transition metals, the abatement efficiencies of micropollutants by catalytic ozonation could be satisfactorily predicted by the chemical kinetic model using the O3 and OH rate constants of the micropollutants reported in literature and the O3 and OH exposures determined during the treatment processes. These results demonstrate that the chemical kinetic model can provide a useful tool for the generalized prediction of micropollutant abatement by homogeneous catalytic ozonation.

Modeling of Catalyst Deactivation in Humic Acid Degradation

Kinetic Model and Simulation Analysis for Toluene Disproportionation and C9-Aromatics Transalkylation

Experimental study of humic acid degradation and theoretical modelling of catalytic ozonation

Low-temperature Degradation of Humic Acid Via Titanium Zirconium Oxide@copper Single-Atom Activating Oxygen: Mechanism and Pathways

Kinetic Modeling for the Deactivation of TiO2 During the Photocatalytic Removal of Low Concentration SO2

Mechanism and Toxicity Evaluation of Catalytic Ozonation over Cu/Ce–Al2O3 System Aiming at Degradation of Humic Acid in Real Wastewater

Intrinsic kinetic model with variable light intensity of the emerging pollutants degradation in a photocatalytic differential reactor with immobilized TIO2: Experiments and CFD

Catalytic Degradation of Humic Acid by Mn-Cu/Al-MCM-41 Catalyst in Electro-Fenton/Chlorine Processes: Influencing Factors, Mechanisms, and Kinetics

Novel kinetic modeling of photocatalytic degradation of ethanol and acetaldehyde in air by commercial and reduced ZnO: Effect of oxygen vacancies and humidity

A Kinetic Model Considering Catalyst Deactivation for Methanol-to-Dimethyl Ether on a Biomass-Derived Zr/P-Carbon Catalyst

Catalytic Cracking and Catalyst Deactivation/regeneration Characteristics of Fe-loaded Biochar Catalysts for Tar Model Compound

Efficiency of Ag3PO4/TiO2 as a heterogeneous catalyst under solar and visible light for humic acid removal from aqueous solution

Modeling of catalyst poisoning during hydrogen production via methane steam and dry reforming

Prediction of Micropollutant Abatement During Homogeneous Catalytic Ozonation by a Chemical Kinetic Model.

Modeling TiO 2 /UV–vis bacterial inactivation: Useful tools for reactor optimization and design

Modelling of Emerging Contaminant Removal During Heterogeneous Catalytic Ozonation Using Chemical Kinetic Approaches.

A Model of Catalytic Cracking: Catalyst Deactivation Induced by Feedstock and Process Variables

Modeling kinetics of Cu(II) release during Fe oxide transformation under the influence of humic substances

Kinetic Modeling of Electro-Fenton Reaction in Aqueous Solution

A “deactivation” Kinetic Model for Predicting the Performance of Photocatalytic Degradation of Indoor Toluene, O-Xylene, and Benzene

Bismuth catalyst mediated degradation of p-hydroxyphenylacetic acid: Photoactivation, interfacial mechanism, and influence of some critical parameters