Abstract:This paper is to study the influence of sulphate corrosion on the mechanical behaviors of concrete, especially concrete corrosion under actual corrosion environment. This study investigated different immersion methods for concrete in a corrosion environment, and different strengths of concrete specimens with contents of sodium sulphate and magnesium chloride of 10.36% and 12.00%, respectively. Strength tests were performed on the specimens for the different immersion methods of full immersion, half-immersion, and dry-wet cycles, and with different strengths for the concrete of C20, C35, and C50. To study the internal mechanisms of the corrosion of concrete with different immersion methods and different strengths, a microscopic pore structure test was conducted. The field tests were performed after 12 years to evaluate the long term performance of the concrete under the actual environmental conditions. The test results show that full immersion mainly led to chemical corrosion, half immersion led to double damage from salt crystallization and chemical corrosion, and dry-wet cycles accelerated the corrosions of the salt crystallization and chemical corrosion. The higher the strength of concrete, the better its resistance to the sulphate corrosion. In comparison with the strength of the concrete before corrosion, field test results show that the strength of uncorroded concrete after 12 years is increased by 9.5% and the strength of corroded concrete after 12 years is reduced by 56.2%. The results of the strength tests and pore structure tests show that sulphate has a significant impact on concrete strength after 12 years of field tests. This study will contribute to improve long-term performance of the concrete, provide guidance for concrete structure design in corroded areas, and suggested that increasing attention should be paid to the effects of sulphate on concrete performance.

Corrosion Behavior of AISI 1018 Reinforcing Steel in Sustainable Concrete made with Sugar Cane Bagasse Ash and Recycled Aggregates Exposed in Seawater

Steel Corrosion and Corrosion-Induced Cracking in Reinforced Concrete with Carbonated Recycled Aggregate

Corrosion Behavior of AISI 304 Stainless Steel Reinforcements in SCBA-SF Ternary Ecological Concrete Exposed to MgSO4

Enhancing the Corrosion Resistance of Recycled Aggregate Concrete by Incorporating Waste Glass Powder

Chloride corrosion of embedded reinforced steel on concrete elaborated from recycled coarse aggregates and supplementary cement materials

Evaluating corrosion resistance of recycled aggregate concrete integrating ground granulated blast furnace slag

Electrochemical Corrosion Behavior of Carbon Steel Reinforcement in Concrete Containing Limestone and Mesoporous Silica Nanoparticles under Acidic Environment

EIS Investigation of the Corrosion Behavior of Steel Bars Embedded into Modified Concretes with Eggshell Contents

Effect of Bagasse Ash Admixture on Corrosion Behavior of Low Carbon Steel Reinforced Concrete in Marine Environment

Study of Wiring Method on Accelerated Corrosion of Steel Bars in Concrete

The Electrochemical Characterization of Rebar Passivation Film in Simulated Concrete Media

Alkali-activated concretes based on high unburned carbon content fly ash: carbonation and corrosion performance

Application of Electrochemical Impedance Spectroscopy to Evaluate the Corrosion Behavior of 2304 Duplex Stainless Steel Reinforced Rebar in Concrete Exposed in Chloride-Rich Environment

Effect of coarse calcareous aggregates on corrosion of steel reinforcement in marine concretes

Durability of Steel Reinforced Concrete Using Limestone, Sea Sand and Seawater in Concrete Mix

Electrochemical Investigations of Steels in Seawater Sea Sand Concrete Environments

Calcined Clay and Limestone as Partial Replacements of Portland Cement: Electrochemical Corrosion Behavior of Low Carbon Steel Rebar as Concrete Reinforcement in Corrosive Environment

Compressive strength and corrosion behavior of steel bars embedded in concrete produced with ferronickel slag aggregate and fly ash: an experimental study

Effect of Sugarcane Bagasse Ash and Ceramic Waste Dust as Partial Replacements of Portland Cement on Corrosion Behavior of HRB400 Low Carbon Steel Reinforcement in 3.5 % NaCl

Influence mechanisms under different immersion methods and different strengths of concrete in corrosive environments, and verification via long-term field test

Influence of Steel Slag on Mechanical Properties and Durability of Concrete