Development of Highly Efficient and Durable Large-Area Solid Oxide Fuel Cell by a Direct-Ink-Writing Three-Dimensional Printer

Manasa Kumar Rath,Alexey Kossenko,Viktor Danchuk,Mikola Shatalov,Or Rahumi,Konstantin Borodianskiy,Michael Zinigrad,Trilochan Sahoo,Satrujit Mishra

DOI: https://doi.org/10.2139/ssrn.4180289

2022-01-01

SSRN Electronic Journal

Abstract:The commercialization of efficient and durable solid oxide fuel cells is hugely hindered due to the expensive and complex fabrication process. In this regard, the additive manufacturing technique, i.e., three-dimensional printing has gained tremendous attention because of its ability to fabricate tunable functional ceramic layers with cost-effectiveness and mass customization. Therefore, in this work, the anode and cathode of the large-area SOFC (5×5 cm2) are printed using a direct-ink-writing (DIW) printer. The viscosity of the optimized anode and cathode inks are 5.85 Pa s and 0.97 Pa s, respectively. The electrochemical impedance and the performance of 3D-SOFC are investigated by supplying hydrogen and air. The maximum power density of the cell is 368 mW·cm -2 at 800 °C. However, by inserting a scandia stabilized zirconia layer by magnetron sputtering onto the AFL, the performance of the cell enhanced by 25%; the peak power density is 460 mW cm -2 , and the corresponding polarization resistance is 0.296 Ω cm 2 at 800 °C. Furthermore, the long-term cell test under galvanostatic mode (j=0.5 A cm -2 ) at 700 °C for 100 h and thermal cycling between 400-700 °C concludes that the 3D-SOFC exhibits exceptional stability.