Abstract:Using granulated blast furnace slag (GGBS) as the volcanic ash material and fly ash (FA) as the supplementary material, the study was conducted to investigate the mix proportions of an alkali-activated solid waste cementitious material under the stimulating effect of alkali activator carbide slag (CS). This type of cementitious material could serve as a substitute for a portion of cement usage, contributing to resource conservation and mitigating environmental pollution caused by solid waste. This facilitates green and sustainable development. Firstly, an analysis of three raw materials was conducted, and the mix proportions were designed with reference to the CaO-Al 2 O 3 -SiO 2 system of Portland cement. Then 28 groups of specimens were prepared based on the designed mix proportions. The flowability and setting time of each group of specimens were tested. It was observed that an increase in the amount of CS and a decrease in the amount of GGBS resulted in decreased flowability and earlier setting times of the specimens. Additionally, FA exhibited a retarding effect on setting time. Compressive strength tests were conducted on these specimens, revealing that the optimal CS content ranged between 20 % and 40 %. Overall, FA had minimal impact on compressive strength, but it contributed to increased compressive strength in the specimens at later ages. Subsequently, microscopic characterization of the hydration products was performed using X-ray Diffraction (XRD), Fourier Transform Infrared (FTIR), Differential Thermal Analysis (DTA), Scanning Electron Microscope (SEM), and Energy Dispersive Spectrometer (EDS). The hydration products were identified as predominantly composed of calcium silicate hydrate. The quality and defects in the microstructure of gel products from various specimen formulations were compared to elucidate differences in macroscopic performance. Finally, the hydration process mechanism diagram of alkali-activated materials was presented to illustrate the stimulation and formation of gel products, primarily composed of C-S-H. This diagram revealed the principles behind the action of alkali-activated cementitious materials. The proposed design and testing methodology for the GGBS-FA-CS system in this study had certain reference significance for research in the direction of alkali-activated solid waste cementitious materials.

Carbide slag–activated ground granulated blastfurnace slag for soft clay stabilization

Utilization of lime/carbide slag-activated ground granulated blast-furnace slag for dredged sludge stabilization

Study on Mixing Cement-Waste By-Product to Stabilize Soft Marine Clay

Effect of carbide slag and steel slag as alkali activators on the key properties of carbide slag-steel slag-slag-phosphogypsum composite cementitious materials

Utilization of carbide slag-granulated blast furnace slag system by wet grinding as low carbon cementitious materials

Experimental Study on Mechanical Properties of Soft Clay Stabilized by Industrial By-Products

Study on Strength, Water Stability, Shrinkage, and Microstructure of CFB Slag Modified Cement Stabilized Clay

Preparation and Characterization of Low-Carbon Cementitious Materials Based on Soda-Residue-Activated Ground Granulated Blast-Furnace Slag: A Case Study on Cemented Paste Backfills

Stabilization of a Clay Soil Using Cementing Material from Spent Refractories and Ground-Granulated Blast Furnace Slag

Incorporation of reactive magnesia and quicklime in sustainable binders for soil stabilisation

Optimization of synergy between cement, slag, and phosphogypsum for marine soft clay solidification

Comparison between CaO- and MgO-activated ground granulated blast-furnace slag (GGBS) for stabilization/solidification of Zn-contaminated clay slurry

Study on the optimization and performance of GFC soil stabilizer based on response surface methodology in soft soil stabilization

Research on Alkali-Activated Slag Stabilization of Dredged Silt Based on a Response Surface Method

Initial Investigation of Soil Stabilization with Calcined Dolomite-GGBS Blends

Physical-chemical coupling excitation of low activity coal gasification slag solid waste and its application as a backfill cementitious material

Use of recycled gypsum in the cement-based stabilization of very soft clays and its micro-mechanism

Comparison of Mechanical Properties of the Geopolymer-Solidified Soils Activated by Two Alkaline Oxides

Effects of carbide slag on the performance of phosphogypsum backfill paste

Geotechnical Investigations on Marine Clay Stabilized Using Granulated Blast Furnace Slag and Cement

Study on the preparation, performance, and mechanism for solid waste cementitious materials