Abstract:Abstract A highly accurate digital-twin spiral bevel gear or hypoid gear is often required for dynamic analysis or stress analysis for gear transmission. However, a highly accurate digital-twin solid model is not always available because the final hypoid gear is completed by the gear manufacturer. This study constructs a digital-twin from a sample hypoid gear. The tooth surface of sample gear is digitized as topographical grids using a coordinate measuring machine (CMM) or a gear measurement center. The geometric parameters (the surface position vector, the normal vector, the principal curvatures, and the corresponding principal directions) for the measured tooth surface (MTS) are then extracted using numerical differential geometry (NDG). The machine settings and the cutter parameters for the sample hypoid gear are obtained by minimizing the topographical error between the replicated digital-twin and the sample gear using optimization software. The initial estimation for the machine settings and the cutter parameters is calculated using an explicit form of the modified-roll motion (MRM), which decreases numerical divergence and time that is required for calculation. The machine settings, the cutting tool parameters, and the auxiliary flank modification (AFM) motion are used as the design variables. A numerical example is presented to verify the proposed methodology. The numerical results show that the replicated digital-twin that is developed using the proposed method is sufficiently accurate for industrial applications.

Nonlinear correction of hypoid gear machine tool parameters by duplex helical method

A New Algorithm for Pitch Parameters of Hypoid Gear Drive

Tooth Surface Error Correction of Hypoid Gears Machined by Duplex Helical Method

Quasi-static Tooth Contact Analysis of Hypoid Gear Drive with Coaxiality Deviations

Nonlinear Vibration Characteristics of Helical Bevel Gear Systemand Parameters Influences

Flank Error Correction of Hypoid Gears Based on Regression Analyses

Active tooth surface design of cycloid hypoid gears

Computerized Design and Generation of Low-Noise Helical Gears with Modified Surface Topology

Modelling method, simulation and experimental verification of hypoid gear involved tooth surface deviation under manufacturing process

Optimization of bias modification and dynamic behavior analysis of helical gear system

Hobbing Manufacturing of New Type of Involute-Helix Gears for Wind Turbine Gearbox

Computerized approach for design and generation of face-milled non-generated hypoid gears with low shaft angle

A Way to Improve the Accuracy of Hobbed Involute Gears

Cutting Force Fluctuation Suppression and Error Homogenization of Noncircular Gear Hobbing Based on the Tool Shifting Method

A method for the global optimization of the tooth contact pattern and transmission error of spiral bevel and hypoid gears

Tooth surface geometry optimization of spiral bevel and hypoid gears generated by duplex helical method with circular profile blade

A novel gear flank modification methodology on internal gearing power honing gear machine

Multi-objective optimization of the manufacture of face-milled hypoid gears on numerical controlled machine tool

Optimization of machine tool settings for Spirac hypoid gears by controlling symmetry of contact paths

Linkage model and interpolation analysis of helical non-circular gear hobbing

Study on Building Digital-Twin of Face-Milled Hypoid Gear From Measured Tooth Surface Topographical Data