Abstract:Introduction: Manual handling personnel and those performing manual handling tasks in non-traditional manual handling industries continue to suffer debilitating and costly workplace injuries. Smart assistive devices are one solution to reducing musculoskeletal back injuries. Devices that provide targeted assistance need to be able to predict when and where to provide augmentation via predictive algorithms trained on functional datasets. The aim of this study was to describe how an increase in load impacts spine kinematics during a ground-to-platform manual handling task. Methods: Twenty-nine participants performed ground-to-platform lifts for six standardised loading conditions (50%, 60%, 70%, 80%, 90%, and 100% of maximum lift capacity). Six thoracic and lumbar spine segments were measured using inertial measurement units that were processed using an attitude-heading-reference filter and normalised to the duration of the lift. The lift was divided into four phases weight-acceptance, standing, lift-to-height and place-on-platform. Statistical significance of sagittal angles from the six spine segments were identified through statistical parametric mapping one-way analysis of variance with repeated measures and post hoc paired t-tests. Results: Two regions of interest were identified during a period of peak flexion and a period of peak extension. There was a significant increase in spine range of motion and peak extension angle for all spine segments when the load conditions were increased ( p 80% maximum lift capacity, inclusive) to light loads (<80% maximum lift capacity) ( p < 0.001). Discussion: The 50%–70% maximum lift capacity conditions being significantly different from heavier load conditions is representative that the kinematics of a lift do change consistently when a participant's load is increased. The understanding of how changes in loading are reflected in spine angles could inform the design of targeted assistance devices that can predict where and when in a task assistance may be needed, possibly reducing instances of back injuries in manual handling personnel.

Characterizing the Compressive Force at L5/S1 During Patient Transfer From Bed to Wheelchair

Biomechanical stresses on healthcare workers during manual patient bed-to-chair transfers

Biomechanical comparison between manual and motorless device assisted patient handling: sitting to and from standing position

A preliminary biomechanical assessment and user perceptions of a motorized lifter for patient transfer

Estimating Compressive and Shear Forces at L5-S1: Exploring the Effects of Load Weight, Asymmetry, and Height Using Optical and Inertial Motion Capture Systems

Save Your Back: Comparison of the Compressive Force on the Lower Back Based on Differences in the Training Techniques

The effects of back belts and load on selected lifting kinematics during a simulated patient transfer

Effect of low back pain on the kinetics and kinematics of the lumbar spine - a combined in vivo and in silico investigation

The highs and lows of lifting loads: SPM analysis of multi-segmental spine angles in healthy adults during manual handling with increased load

Efficacy of lifting devices for wheelchair transfers: a systematic review and meta-analysis

Time Efficiency and Ergonomic Assessment of a Robotic Wheelchair Transfer System

In vivo load on knee, hip and spine during manual materials handling with two lifting techniques

Proposal for a Human–Machine Collaborative Transfer System Considering Caregivers' Lower Back Pain and Cognitive Factors in the Elderly during Transfer Movements

Kinematic analysis of preparation for transferring from wheelchair to bed

Experimental evaluation of a novel robotic hospital bed mover with omni-directional mobility

Analysis of Comfort during Transfer by a Dual-Arm Care Robot Based on Human Body Pressure and Surface Electromyographic Signals

Impact of Lifting Load, Speed and Posture on Force at Lumbar L5/S1 Joint of Lifting Simulation in Molding Task

A randomized controlled trial to prevent patient lift and transfer injuries of health care workers

Analysis of squat and stoop dynamic liftings: muscle forces and internal spinal loads

Development of a sit-to-stand assistive device with pressure sensor for elderly and disabled: a feasibility test

Using Digital Human Modelling to Evaluate the Risk of Musculoskeletal Injury for Workers in the Healthcare Industry