Abstract:This article introduces a liquid desiccant fresh air processor. Its driving force is low-grade heat (heat obtained from 65 – 75°C hot water). Inside the processor, the air is dehumidified by the evaporative cooling energy of the indoor exhaust air. A four-stage structure is used to increase the efficiency of the combined sensible and latent heat recovery from the exhaust air. A mathematical model of the fresh air processor was set up using Simulink®. A liquid desiccant fresh air processor was constructed and tested for outside air conditions of 29.1 – 33.6°C, 13.7 – 16.7g/kg humidity ratio, and supply air conditions of 23.6 – 24.2°C, 7.4 – 8.6g/kg humidity ratio. The average measured COP f was 1.6 (cold production divided by latent heat removed) for the range of conditions tested. The corresponding average COP sys of the system including the regenerator was 1.3 (cold production divided by heat input). The detailed operating parameters of each part of the test unit were also measured. The test data was compared with the simulated performance. The characteristic coefficients (such as the volumetric mass transfer coefficient of the air-water evaporative cooling module, etc.) in the mathematical model were modified to calibrate the model output to the measured data. The calibrated simulation model was used to investigate the control strategy of the fresh air processor. The flow rate of the strong solution into the unit and the number of operation stages may be controlled separately or together to meet different indoor air requirements at different outdoor conditions. The hot water driven liquid desiccant air conditioning system was compared with a typical vapor compression system with an average COP of 4.5; the pump and fan power of the proposed system was 40% of the combined chiller, pump, and fan consumption. We achieved savings of over 30% of the power consumption compared with the traditional system under the designed outdoor air conditions.

Establishment and Application of the Energy Consumption Model for a Novel Dual-Suction Compressor

Simplified Modeling of an Inverter Air Conditioner Based on Experimental Data

Theoretical Analyses of a New Two-Stage Absorption-Transcritical Hybrid Refrigeration System

Steady-State Performance Prediction for a Variable Speed Direct Expansion Air Conditioning System Using a White-Box Based Modeling Approach

A modeling study on a direct expansion based air conditioner having a two-sectioned cooling coil

Experimental and Theoretical Assessments on the Systematic Performance of a Single-Stage Air-Source Heat Pump Using Ternary Mixture in Cold Regions

Theoretical Investigations on the Cycle Performance of a Single-Pressure Diffusion Absorption Heat Transformer with LiBr–H2O-R134a-TEGDME

SIMULATION AND COMPARISON OF AIR-SOURCE HEAT PUMPS USING VARIABLE COMPOSITION AND CONSTANT COMPOSITION MIXTURES OR PURE REFRIGERANT

Performance representation of variable-speed compressor for inverter air conditioners based on experimental data

Simulation Research on Refrigeration Performance of Piston Compressor with Double Suction Ports

A computer simulation of a rotary compressor for household refrigerators

Performance evaluation of air-source heat pump based on a pressure drop embedded model

Cooling and Dehumidification Performance Study of a New Air Conditioning System with Double Evaporation Temperature

System optimization of steam generation in the dual-flash compound circulation system

Simulation and Experimental Analysis of A Fresh Air-Handling Unit with Liquid Desiccant Sensible and Latent Heat Recovery

Simulation Study on Single-machine Two-chamber In-parallel Compression Refrigeration/Heat Pump System

Performance optimization of thermoelectric and vapor compression hybrid refrigeration system by allocating power

Development, Calibration, and Validation of a Novel Gray-box Energy Model for Residential Split Air Conditioners

Modeling of Variable Speed Compressors

Experimental study and model optimization of thermodynamic performance of a single screw water vapor compressor

Influence of Parameters on the Estimation of Coefficient of Performance for R410a Refrigerant