Suppressing lithium dendrite via hybrid interface layers for high performance quasi-solid-state lithium metal batteries

Bi Luo,Qi Wang,Weijie Ji,Guihui Yu,Zaowen Zhao,Ruirui Zhao,Bao Zhang,Xiaowei Wang,Jiafeng Zhang

DOI: https://doi.org/10.1016/j.cej.2024.152152

IF: 15.1

2024-05-19

Chemical Engineering Journal

Abstract:The quasi-solid-state metal battery stands out as a promising candidate for the advancement of scalable, safe, and high-performance battery technologies. However, a major challenge remains in the form of short circuits arising from dendrite penetration, a consequence of uneven lithium deposition at the solid electrolyte/lithium anode interface. To address this issue, an in-situ constructed three-dimensional LiCl/Li-Al hybrid protective layer was implemented to inhibit the growth of dendrites. The enhanced interfacial dynamics were meticulously elucidated through a synergistic analysis of simulation and experimental results, highlighting the facilitation of Li + flux distribution and uniform mass transfers introduced by the lithiophilic Li-Al alloy component. As a result, the modified Li anode enables stable Li stripping/plating cycling at a high current density of 1.0 mA·cm −2 and over 500 h at 0.2 mA·cm −2 for 0.2 mAh·cm −2 in the quasi-solid-state symmetric batteries. Additionally, the full cell with a LiFePO 4 cathode maintains a high discharge capacity of 136.2 mAh/g after 400 cycles at 0.5C with a capacity retention of approximately 90 %. These findings demonstrate the application potential of Li anodes with a surface treatment for quasi-solid-state lithium metal battery applications.

engineering, chemical, environmental