Abstract:Magnesium (Mg) and its alloys offer great potential for reducing vehicular mass and energy consumption due to their inherently low densities. Historically, widespread applicability has been limited by low strength properties compared to other structural Al-, Ti- and Fe-based alloys. However, recent studies have demonstrated high-specific-strength in a number of nanocrystalline Mg-alloys. Even so, applications of these alloys would be restricted to low-temperature automotive components due to microstructural instability under high temperature creep loading. Hence, this work aims to gain a better understanding of creep and associated deformation behavior of columnar nanocrystalline Mg and Mg-yttrium (Y) (up to 3at.%Y(10wt.%Y)) with a grain size of 5 nm and 10 nm. Using molecular dynamics (MD) simulations, nanocrystalline magnesium with and without local concentrations of yttrium is subjected to constant-stress loading ranging from 0 to 500 MPa at different initial temperatures ranging from 473 to 723 K. In pure Mg, the analyses of the diffusion coefficient and energy barrier reveal that at lower temperatures (i.e., T < ~423K) the contribution of grain boundary diffusion to the overall creep deformation is stronger that the contribution of lattice diffusion. However, at higher temperatures (T > ~423K) lattice diffusion dominates the overall creep behavior. Interestingly, for the first time, we have shown that the(101-1),(101-2),(101-3) and (101-6) boundary sliding energy is reduced with the addition of yttrium. This softening effect in the presence of yttrium suggests that the experimentally observed high temperature beneficial effects of yttrium addition is likely to be attributed to some combination of other reported creep strengthening mechanisms or phenomena such as formation of stable yttrium oxides at grain boundaries or increased forest dislocation-based hardening.

The synergistic effects of nano-sized α-Al(Mn,Cr,Fe)Si and Al–Si–Zr dispersoids on the creep behavior Al–Si–Mg–Cu (Mn, Cr, Zr) diesel engine alloy

Abnormal creep behavior of Mg-12Gd-1MM-0.6Zr (wt.%) alloy at 300C

Creep Behavior and Deformation Mechanism of a Third-Generation Single Crystal Ni-Based Superalloy at 980 °C

Creep behaviour and microstructural evolution of Al x CrMnFeCoNi high-entropy alloys

Abnormal creep behavior of Mg–12Gd–1MM–0.6Zr (wt.%) alloy at 300°C

Unveiling the Microstructure Evolution and the Short-Time Tensile Creep Behavior in the CuCrZr Alloy

Microstructure Evolution and Creep Behavior of High-Pressure Die-Cast Mg–9Al–1Zn–1Sr Alloy

Creep Behaviours of Cr25Ni35Nb and Cr35Ni45Nb Alloys Predicted by Modified Theta Method

Solute-induced strengthening during creep of an aged-hardened Al-Mn-Zr alloy

Atomic-scale investigation of creep behavior in nanocrystalline Mg and Mg-Y alloys

Cavitation-resistant intergranular precipitates enhance creep performance of θ'-strengthened Al-Cu based alloys

Recent Progress in Creep-Resistant Aluminum Alloys for Diesel Engine Applications: A Review

Co-deformation Between the Metallic Matrix and Intermetallic Phases in a Creep-Resistant Mg-3.68Al-3.8Ca Alloy

An additively manufactured near-eutectic Al-Ce-Ni-Mn-Zr alloy with high creep resistance

Stabilizing Al–Mg–Si–Cu alloy by precipitation nano-phase control

Compressive creep behavior of extruded Mg-4Sm-2Yb-0.6Zn-0.4Zr alloy

Modeling and measurements of creep deformation in laser-melted Al-Ti-Zr alloys with bimodal grain size

Nanoindentation Creep Behavior of an Al0.3CoCrFeNi High-Entropy Alloy

Tensile creep behaviors of Mg-10Gd-0.4Zr alloy in different heat treatment states

An investigation on creep deformation and mechanical properties of a polycrystalline Fe-based alloy: a molecular dynamics study

Microstructural evolution of Mg–14Gd–0.4Zr alloy during compressive creep