Abstract:Silicon carbide (SiC) devices have the potential to yield new components with functional capabilities that far exceed components based on silicon devices. Selective doping of SiC by ion implantation is an important fabrication technology that must be completely understood if SiC devices are to achieve their potential. One major problem with ion implantation into SiC is the surface roughening that results from annealing SiC at the high temperatures which are needed to activate implanted acceptor ions, boron or aluminum. This paper examines the causes and possible solutions to surface roughening of implanted and annealed 4H-SiC. Samples consisting of n-type epilayers (5 × 1015 cm−3, 4 µm thick) on 4H-SiC substrates were implanted with B or Al to a total dose of 4 × 1014 cm−2 or 2 × 1015 cm−2, respectively. Roughness measurements were made using atomic force microscopy. From the variation of root mean square (rms) roughness with annealing temperature, apparent activation energies for roughening following implantation with Al and B were 1.1 and 2.2 eV, respectively, when annealed in argon. Time-dependent activation and surface morphology analyses show a sublinear dependence of implant activation on time; activation percentages after a 5 min anneal following boron implantation are about a factor of two less than after a 40 min anneal. The rms surface roughness remained relatively constant with time for anneals in argon at 1750°C. Roughness values at this temperature were approximately 8.0 nm. Annealing experiments performed in different ambients demonstrated the benefits of using silane to maintain good surface morphology. Roughnesses were 1.0 nm (rms) when boron or aluminum implants were annealed in silane at 1700°C, but were about 8 and 11 nm for B and Al, respectively, when annealed in argon at the same temperature.

Ion Doping of Silicon Carbide in the Technology of High-Power Electronic Devices (Review)

Ion Implantation Doping in Silicon Carbide and Gallium Nitride Electronic Devices

Selective Doping in Silicon Carbide Power Devices

Characterizations on the Doping of Single-Crystal Silicon Carbide

A Multiscale Simulation on Aluminum Ion Implantation-Induced Defects in 4H-SiC MOSFETs

Hyperdoped silicon: Processing, properties, and devices

Research on dopant distribution of multi-energy boron implantations into c-SiC

Investigation of the Doping Profile for Ion Implants and Rapid Annealing in Silicon Via an Improved Method

Critical issues in the formation of quantum computer test structures by ion implantation

Transient Scanning Electron Beam Annealing Methods Used to Study Diffusion and Defects in Implanted Silicon

Design consideration of ion implantation in dopant segregation technique at NiSi/Si interface

Ion-Beam-Induced Defects in CMOS Technology: Methods of Study

Effects of Thermal Annealing Processes in Phosphorous Implanted 4H-SiC Layers

Electrical properties of silicon-implanted β-Ga2O3:Fe crystals

Ion implantation of low energy Si into graphene: insight from computational studies

Thermal Diffusion Boron Doping of Single-Crystal Diamond

Displacement damage and total ionisation dose effects on 4H‐SiC power devices

Engineering of the spin on dopant process on silicon on insulator substrate

Recent Progress on Single-Crystal Growth and Epitaxial Growth of 4H Silicon Carbide

Surface roughening in ion implanted 4H-silicon carbide

Numerical investigation of laser doping parameters for semi-insulating 4H-SiC substrate