Poisoning mechanism of KCl, K2O and SO2 on Mn-Ce/CuX catalyst for low-temperature SCR of NO with NH3
Lin Chen,Shan Ren,Xiangdong Xing,Jie Yang,Xiaodi Li,Mingming Wang,Zhichao Chen,Qingcai Liu
DOI: https://doi.org/10.1016/j.psep.2022.09.031
IF: 7.8
2022-11-01
Process Safety and Environmental Protection
Abstract:In this study, a series of K species or/and SO2 poisoned Mn-Ce doped CuX (MCCX) catalysts were prepared from waste blast furnace slag (BFS), and the influence mechanism of K species or/and SO2 poisoning on the catalysts in low-temperature NH3-SCR process was investigated. The results demonstrated that MCCX-KCl catalyst had poorer NO conversion than MCCX-K2O below 200 °C, and the co-existence of K species and SO2 considerably inhibited NO conversion. Aggregation of the Cu active component might also be facilitated by co-poisoning with K species and SO2. Furthermore, K species and SO2 co-poisoned catalysts showed fewer isolated Cu2+ species and Mn4+ species than that of K-poisoned catalysts, indicating a decrease in active sites after the addition of SO2. The co-effect of K2O/KCl and SO2 species impaired the redox capacity and decreased the surface acidity than K-poisoned catalysts to a greater extent. Nevertheless, K-poisoning had little effect on the surface intermediates during SCR reaction process, and K-poisoned catalysts followed both Langmuir-Hinshelwood (L-H) and Eley-Rideal (E-R) mechanism. However, MCCX-KCl-SO2 and MCCX-K2O-SO2 catalysts contained fewer nitrate species, indicating that the co-effect of K species and SO2 impeded the reaction between NO + O2 species and pre-NH3 species, thereby resulting in poor low-temperature NH3-SCR activity.
engineering, environmental, chemical