Abstract:The reason that p-GaN gate normally-off high electron mobility transistor (HEMT) device is able to draw prevail interests is not only for its outstanding electric properties of low on-resistance and high thermal conductivity, but also for its applications under high frequency and high voltage. In HEMT devices, the setting of Al component in the AlGaN barrier layer is a key parameter to affect the formation of two-dimensional electron gas (2DEG) at the AlGaN/GaN heterojunction, and therefore directly determines the performance of the devices. This paper uses the Atlas module of the Silvaco-TCAD software to design and simulate p-GaN gate normally-off HEMT devices to investigate the effect of Al mole fraction content in the AlGaN barrier layer on the electrical performance, as well as the causes in terms of the conduction band energy structure diagram. The results show that the threshold voltage of the HEMT device decreases, the maximum saturation drain current increases, and the peak transductance of the HEMT device increases with increasing the Al content. In the off-state (zero gate voltage), the AlGaN/GaN potential well depth becomes deeper as the Al mole fraction increases, resulting in a lower driven force to rebuild the minimized 2DEG concentration in the GaN layer for switching from off-state to on-state, and this leads to a lower threshold voltage. While, in the on-state (5 V gate voltage), the deeper AlGaN/GaN potential well depth as the Al mole fraction increases, the higher of the 2DEG concentration of the GaN layer, leading to a higher maximum saturation output drain current. After optimization, the integrated electrical performance of the HEMT devices has been found best when the Al mole fraction content is about 0.25. The results obtained from the simulations are helpful for the experimental design of p-GaN gate normally-off HEMT devices

Low-Mg out-diffusion of a normally off p-GaN gate high-electron-mobility transistor by using the laser activation technique

Impact of Mg out-diffusion and activation on the p-GaN gate HEMT device performance

High-performance Normally off AlGaN/GaN High Electron Mobility Transistor with P-Type H-Bn Cap Layer

Improved Device Performance in AlGaN/GaN HEMT by Forming Ohmic Contact with Laser Annealing

Normally-off GaN HEMTs with InGaN P-Gate Cap Layer Formed by Polarization Doping

Normally-Off p-GaN Gated AlGaN/GaN MIS-HEMTs with ALD-Grown Al2O3/AlN Composite Gate Insulator

AlN/GaN HEMTs with f max Exceeding 300 GHz by Using Ge-Doped n ++ GaN Ohmic Contacts

AlN/GaN HEMTs with Fmax Exceeding 300 GHz by Using Ge-Doped N++gan Ohmic Contacts

p-GaN Gate HEMTs With 10.6 V Maximum Gate Drive Voltages by Mg Doping Engineering

High-performance normally off p-GaN gate high-electron-mobility transistor with In 0.17 Al 0.83 N barrier layer design

Enhancement-mode GaN HEMT using a combination structure of recessed-gate and p-GaN gate structure

Current-collapse Suppression and Leakage-Current Decrease in AlGaN/GaN HEMT by Sputter-Tan Gate-Dielectric Layer

Influence of Mg doping level at the initial growth stage on the gate reliability of p-GaN gate HEMTs

High-performance normally off p-GaN gate high-electron-mobility transistor with In0.17Al0.83N barrier layer design

High-Performance Normally-Off Operation p-GaN Gate HEMT on Free-Standing GaN Substrate

Mg activation anneal of the p-GaN body in trench gate MOSFETs and its effect on channel mobility and threshold voltage stability

Activating Thick Buried P-Gan for Device Applications

Simulation study on electrical properties of p-GaN gate normally-off HEMT devices affected by Al mole fraction in AlGaN barrier layer

Normally-Off Schottky-Gate P-Gan HEMTs with Enhanced Irradiation Hardness

Current collapse suppression in AlGaInN/GaN HEMTs with thin unintentionally doped GaN channel and AlN back barrier grown on single-crystal AlN substrate

Realization of P-Type Gallium Nitride by Magnesium Ion Implantation for Vertical Power Devices