A Review on the Modeling of Direct Reduction of Iron Oxides in Gas‐Based Shaft Furnaces

Ariyan Zare Ghadi,Navid Radfar,Mohammad Sadegh Valipour,Hong Yong Sohn
DOI: https://doi.org/10.1002/srin.202200742
IF: 2.1258
2023-03-17
steel research international
Abstract:Although the blast furnace process is the dominant ironmaking route to supply the feedstocks for steelmaking, a number of alternative ironmaking technologies such as the Direct Reduced Iron (DRI) process have grown rapidly in recent decades. This development is largely in response to the increasingly stringent emission control policies, rising costs of energy and the increasing costs and environmental effects of coke usage. In the DRI processes, iron oxides are reduced to iron at a temperature below its melting point, unlike in the blast furnace where a molten metal is produced. More than 79% of direct reduced iron has been produced by Midrex and Energiron, both of which use gas‐based shaft furnaces. A proper understanding of these processes is required to improve the performance and operation of the plants based on them. Therefore, this paper is aimed to provide a comprehensive review of research that has been carried out over the last several decades to examine the effects of the important phenomena on the performance of the gas‐based shaft furnaces. The review is divided into experimental and mathematical investigations. The main features, limitations, and shortcomings of each study are discussed. Finally, the review concludes with current knowledge gaps and suggestions for further research in this thriving sector of the steel industry. This article is protected by copyright. All rights reserved.
metallurgy & metallurgical engineering
What problem does this paper attempt to address?