Abstract:Piezoelectric wafer active sensors (PWAS) have been proven a valuable tool in structural health monitoring. Piezoelectric wafer active sensors are able to send and receive guided Lamb/Rayleigh waves that scan the structure and detect the presence of incipient cracks and structural damage. In-situ thin-film active sensor deposition can eliminate the bonding layer to improve the durability issue and reduce the acoustic impedance mismatch. Ferroelectric thin films have been shown to have piezoelectric properties that are close to those of single-crystal ferroelectrics but the fabrication of ferroelectric thin films on structural materials (steel, aluminum, titanium, etc.) has not been yet attempted. In this work, in-situ fabrication method of piezoelectric thin-film active sensors arrays was developed using the nano technology approach. Specification for the piezoelectric thin-film active sensors arrays was based on electro-mechanical-acoustical model. Ferroelectric BaTiO3 (BTO) thin films were successfully deposited on Ni tapes by pulsed laser deposition under the optimal synthesis conditions. Microstructural studies by X-ray diffractometer and transmission electron microscopy reveal that the as-grown BTO thin films have the nanopillar structures with an average size of approximately 80 nm in diameter and the good interface structures with no inter-diffusion or reaction. The dielectric and ferroelectric property measurements exhibit that the BTO films have a relatively large dielectric constant, a small dielectric loss, and an extremely large piezoelectric response with a symmetric hysteresis loop. The research objective is to develop the fabrication and optimum design of thin-film active sensor arrays for structural health monitoring applications. The short wavelengths of the micro phased arrays will permit the phased-array imaging of smaller parts and smaller damage than is currently not possible with existing technology.

Flexible Pb(Zr0.52,Ti0.48)O3 thin film acoustic emission sensor for monitoring partial discharge in power cable

Hierarchically Structured Hollow PVDF Nanofibers for Flexible Piezoelectric Sensor

Ferroelectric Thin-Film Active Sensors for Structural Health Monitoring

Radio-frequency Detection of Partial Discharge in Power Cable Joints

A Fiber-Optic Sensor for Acoustic Emission Detection in a High Voltage Cable System

Heteroepitaxy of flexible piezoelectric Pb(Zr0.53Ti0.47)O3 sensor on inorganic mica substrate for lamb wave-based structural health monitoring

Radiation-Hardened and Flexible Pb(Zr 0.53 Ti 0.47 )O 3 Piezoelectric Sensor for Structural Health Monitoring

Flexible Sensor Array Based on Transient Earth Voltage for Online Partial Discharge Monitoring of Cable Termination

Damage detection for structural health monitoring using ultra-sensitive flexible piezoelectret sensors

Piezoelectric Polyacrylonitrile Nanofiber Film-Based Dual-Function Self-Powered Flexible Sensor.

High-Temperature and Flexible Piezoelectric Sensors for Lamb-Wave-Based Structural Health Monitoring

Highly Sensitive Acoustic Emission Sensor Based on Polarization-maintaining and Absorption-reducing Polarization-maintaining Fiber

A High Sensitivity Optical Fiber Interferometer Sensor for Acoustic Emission Detection of Partial Discharge in Power Transformer

Flexible magnetic sensor based on FBAR

Near-field electrospinning fabrication of piezoelectric polymer microfiber sensors for detection of weak mechanical excitation

A Partial Discharge Detection System for XLPE Cable Terminals and Acoustic Wave Sensing Characteristics Based on Fiber Optic Mach-Zehnder Interferometer

Partial Discharge Ultrasound Detection Using the Sagnac Interferometer System

Acoustic emission sensing in fiber Bragg grating based on phase demodulation for material health detection

Flexible Mica-Based PZT Sensor for Real-Time Monitoring of the Airflow

Structural Damage Detection Using PZT Transmission Line Circuit Model

PD Flexible Built-In High-Sensitivity Elliptical Monopole Antenna Sensor