Abstract:The beneficial effect of the alkali metals such as Na and K on the Cu(In,Ga)Se-2 (CIGS) and Cu2ZnSn(S,Se)(4) (CZTSSe) solar cells has been extensively investigated in the past two decades, however, in most of the studies the alkali metals were treated as dopants. Several recent studies have showed that the alkali metals may not only act as dopants but also form secondary phases in the absorber layer or on the surfaces of the films. Using the first-principles calculations, we screened out the most probable secondary phases of Na and K in CIGS and CZTSSe, and studied their electronic structures and optical properties. We found that all these alkali chalcogenide compounds have larger band gaps and lower VBM levels than CIGS and CZTSSe, because the existence of strong p-d coupling in CIS and CZTS pushes the valence band maximum (VBM) level up and reduces the band-gaps, while there is no such p-d coupling in these alkali chalcogenides. This band alignment repels the photo-generated holes from the secondary phases and prevents the electron-hole recombination. Moreover, the study on the optical properties of the secondary phases showed that the absorption coefficients of these alkali chalcogenides are much lower than those of CIGS and CZTSSe in the energy range of 0-3.4eV, which means that the alkali chalcogenides may not influence the absorption of solar light. Since the alkali metal dopants can passivate the grain boundaries and increase the hole carrier concentration, and meanwhile their related secondary phases have innocuous effect on the optical absorption and band alignment, we can understand why the alkali metal dopants can improve the CIGS and CZTSSe solar cell performance. (C) 2017 Science Pressand Dalian Institute of Chemical Physics, Chinese Academy of Sciences. Published by Elsevier B.V. and Science Press. All rights reserved.

Aluminum‐Based Chalcopyrite Thin Films and Solar Cells

Formation of Alloyed Cu2Cox Zn1-x Sn(S,Se)4 Absorption Layer and Its Application in Solar Cells

Formation of Alloyed Cu2CoxZn1-xSn(S,Se)4 Absorption Layer and Its Application in Solar Cells.

First-principles Study on the Alkali Chalcogenide Secondary Compounds in Cu(In,Ga)Se-2 and Cu2ZnSn(S,Se)(4) Thin Film Solar Cells

Inhibiting Aluminum Oxidation in CuInAl Precursor Films: Significance for Achieving High-Performance Cu(InAl)Se2 Solar Cells

Inhibiting aluminum oxidation in CuInAl precursor films: Significance for achieving high-performance Cu(InAl)Se 2 solar cells

Investigation of CuIn1-xAlxSe2 Thin Film for Solar Cells Prepared by a Selenization Process

Structural, Electronic and Defect Properties of Cu<sub>2</sub>ZnSn(S,Se)<sub>4</sub> Alloys

Effects of Alkali Elements on Copper Indium Gallium Aluminum Selenide Flexible Solar Cells Fabricated on Polyimide Substrates

Compositional Dependence of Structural and Electronic Properties of Cu2ZnSn(S,Se)4alloys for Thin Film Solar Cells

Microstructural and Microchemical Analysis of Chalcopyrite Cu(In,Ga)Se 2 Films

Preparation of Cu(In 1−x Al x )Se 2 thin films by sol-gel method

Structural, Electronic and Defect Properties of Cu 2 ZnSn(S,Se) 4 Alloys

Preparation of Cu(In1−xAlx)Se2 thin films by sol-gel method

Preparation Of Cu(In1-Xalx)Se-2 Thin Films By Sol-Gel Method

Unveiling the potential of CuAl x Ga1- x Se 2 (x=0.25) chalcopyrite as absorbent for photovoltaic application: first-principles insights into the structural, elastic, mechanical, electronic, thermodynamic and optical properties

Single-source Thermal Evaporation Converts Anion Controllable Sb 2 (s,se) 3 Film for Fabricating High-Efficiency Solar Cell

Study of microstructure and optical absorption properties of Cu(In,Ga,Al)Se2 powders

Atom-Scale Chemistry in Chalcopyrite-Based Photovoltaic Materials Visualized by Atom Probe Tomography.

The Effects of Selenium Content on Cu(Inga)Se-2 Thin Film Solar Cells by Sputtering from Quaternary Target with Se-Free Post Annealing

Indium-Gallium Segregation in CuIn$_{x}$Ga$_{1-x}$Se$_2$: An ab initio based Monte Carlo Study