Abstract:Marine and coastal infrastructures usually suffer from synergetic effect of corrosion and wear known as tribocorrosion, which imposes strict requirements on the structural materials used. To overcome this problem, novel composite wear- and corrosion-resistant xTiC-Fe-CrTiNiAl coatings with different TiC content were successfully developed. The coatings were obtained by the original technology of electrospark deposition in a vacuum using xTiC-Cr2Ti-NiAl (x = 0, 25, 50, 75%) electrodes. The structure and morphology of the coatings were studied in detail by XRD, SEM, and TEM. The effect of TiC content on the tribocorrosion behavior of the coatings was estimated using tribological and electrochemical (under stationary and wear conditions) experiments, as well as impact testing, in artificial seawater. The TiC-free Fe-Cr2Ti-NiAl coating revealed a defective inhomogeneous structure with transverse and longitudinal cracks. Introduction of TiC allowed us to obtain coatings with a dense structure without visible defects and with uniformly distributed carbide grains. The TiC-containing coatings were characterized by a hardness and elastic modulus of up to 10.3 and 158 GPa, respectively. Formation of a composite structure with a heavily alloyed corrosion-resistant matrix based on α-(Fe,Cr) solid solution and uniformly distributed TiC grains led to a significant increase in resistance to stationary corrosion and tribocorrosion in artificial seawater. The best 75TiC-Fe-CrTiNiAl coating demonstrated the lowest corrosion current density values both under stationary (0.03 μA/cm2) and friction conditions (0.8 μA/cm2), and was characterized by both a 2-2.5 times lower wear rate (4 × 10−6 mm3/Nm) compared to AISI 420S steel and 25TiC-Fe-CrTiNiAl and a high fracture toughness.

Effect of CrYN/TiBN coating on friction performance and corrosion resistance of 316 Stainless Steel in artificial seawater

Study on Friction and Corrosion Performance of CrTiBN Coating in Artificial Seawater Environment

A comparative analysis of different surface tribological and electrochemical properties of TiAlN, TiAlSiN, and CrAlN thin film coatings in seawater

EFFECT OF MICRO-TEXTURES AND CrAlSiN COATINGS ON THE FRICTION AND WEAR PROPERTIES OF 316L STAINLESS STEELS IN SEAWATER

Influence of multi-interfacial structure on mechanical and tribological properties of TiSiN/Ag multilayer coatings

Tribological and Corrosion Performance of CrAlN/CrN Coatings in Artificial Seawater under Varied Nitrogen Pressures

Improvement in the tribocorrosion performance of CrCN coating by multilayered design for marine protective application

Influence of TiC Addition on Corrosion and Tribocorrosion Resistance of Cr2Ti-NiAl Electrospark Coatings

Surface tribological and electrochemical properties of TiAlSiN coating in seawater

Electrochemical corrosion and tribological properties of CrMoCN coatings sliding against Al2O3 balls in artificial seawater

Microstructure, mechanical properties and tribo-corrosion mechanism of (CrNbTiAlVMo) x N 1-x coated 316 L stainless steel in 3.5 wt.% NaCl solution

Tribocorrosion Properties Of Nicraly Coating In Different Corrosive Environments

Influence of Carbon Contents on the Structure and Tribocorrosion Properties of Tisicn Coatings on Ti6al4v

Corrosion and tribocorrosion behaviors of ternary TiZrN coating on 304 stainless steel prepared by HiPIMS

Tribological and electrochemical properties of Cr–Si–C–N coatings in artificial seawater

Comparative Investigation on the Tribocorrosion Resistance of Ti6Al4V and 60NiTi Alloys in Simulated Seawater Environment

Microstructure and Tribological Properties of Multilayered ZrCrW(C)N Coatings Fabricated by Cathodic Vacuum-Arc Deposition

Electrochemical Behavior of (cr, W, Al, Ti, Si)N Multilayer Coating on Nitrided AISI 316L Steel in Natural Seawater

Effect Of Hybrid Surface Treatment Composed Of Plasma Nitriding And W-Cr-Ti-Al-N Coating On Tribological Behavior Of Aisi 316l Steel

Tribocorrosion characteristics of CrMoSiCN/Ag coatings on Ti6Al4V alloys in seawater

Structure and tribocorrosion behavior of CrMoSiCN nanocomposite coating with low C content in artificial seawater