Abstract:The photon induced radical-initiated polymerization in polymer gels can be used for high-resolution tissue equivalent dosimeters in quality control of radiation therapy. The dose (D) distribution in radiation therapy can be measured as a change of the physical measurement parameter T2 using T2-weighted magnetic resonance imaging. The detection by T2 is relying on the local change of the molecular mobility due to local polymerization initiated by radicals generated by the ionizing radiation. The dosimetric signals R2 = 1/T2 of many of the current polymer gels are dose-rate dependent, which reduces the reliability of the gel for clinical use. A novel gel dosimeter, based on methacrylic acid, gelatin and the newly added dithiothreitol (MAGADIT) as an oxygen-scavenger was analyzed for basic properties, such as sensitivity, reproducibility, accuracy and dose-rate dependence. Dithiothreitol features no toxic classification with a difference to THPC and offers a stronger negative redox-potential than ascorbic acid. Polymer gels with three different concentration levels of dithiothreitol were irradiated with a preclinical research X-ray unit and MR-scanned (T2) for quantitative dosimetry after calibration. The polymer gel with the lowest concentration of the oxygen scavenger was about factor 3 more sensitive to dose as compared to the gel with the highest concentration. The dose sensitivity (α = ∆R2/∆D) of MAGADIT gels was significantly dependent on the applied dose rate D ̇ (≈48% reduction between D ̇ = 0.6 Gy/min and D ̇ = 4 Gy/min). However, this undesirable dose-rate effect reduced between 4–8 Gy/min (≈23%) and almost disappeared in the high dose-rate range (8 ≤ D ̇ ≤ 12 Gy/min) used in flattening-filter-free (FFF) irradiations. The dose response varied for different samples within one manufacturing batch within 3%–6% (reproducibility). The accuracy ranged between 3.5% and 7.9%. The impact of the dose rate on the spatial integrity is demonstrated in the example of a linear accelerator (LINAC) small sized 5 × 10 mm2 10 MV photon field. For MAGADIT the maximum shift in the flanks in this field is limited to about 0.8 mm at a FFF dose rate of 15 Gy/min. Dose rate sensitive polymer gels likely perform better at high dose rates; MAGADIT exhibits a slightly improved performance compared to the reference normoxic polymer gel methacrylic and ascorbic acid in gelatin initiated by copper (MAGIC) using ascorbic acid.

Optical characterization of Fricke-methylthymol blue hydrogel dosimeter with gellan gum as physical cross-linker

Development and characterization of a Fricke gel dosimeter for precise measurement in low-dose photon fields

Characterization of ferrous-xylenol orange-polyvinyl alcohol gel for gamma dosimetry using spectroscopy

Optical investigation of MAGAT polymer gel dosimeter embedded with methylene blue dye and zinc oxide nanoparticles using UV/Vis spectrometry pre- and post-irradiation of 6MV photon beam

Ultrasound evaluation of polymathic methacrylate (PMMA) gel dosimeter doped with copper oxide (CuO) nanoparticles

Feasibility of new polymeric matrices in the production of ferrous sulphate dosimeters

Microscopic and Macroscopic Characterization of Hydrogels Based on Poly(vinyl-alcohol)–Glutaraldehyde Mixtures for Fricke Gel Dosimetry

Magnetic Resonance Imaging Stud of New PAGAT Polymer Gel Dosimeter

Basic Properties of a New Polymer Gel for 3D-Dosimetry at High Dose-Rates Typical for FFF Irradiation Based on Dithiothreitol and Methacrylic Acid (MAGADIT): Sensitivity, Range, Reproducibility, Accuracy, Dose Rate Effect and Impact of Oxygen Scavenger

Characterization of the chemical and structural modifications induced by X rays on the HEMA based polymer gel

Radiation‐sensitive nanogel‐incorporated Fricke hydrogel dosimeters with reduced diffusion rates

A basic study of some normoxic polymer gel dosimeters

Toward “on-line” X-ray computed tomography-based dosimetry using a new polymer gel with rapid response

Dose Response and Stability of Silicone-Based Deformable Radiochromic Dosimeters (flexydos3d) Using Spectrophotometer and Flatbed Scanner

Investigating the performance of susceptibility-weighted images in Fricke gel dosimeter reading and optimizing the related imaging parameters

Study of the Optimal Composition and Storage Conditions of the Fricke–XO–Pluronic F–127 Radiochromic Dosimeter

CCD imaging for optical tomography of gel radiation dosimeters

Preparation and characterization of novel Sulfosalicylic acid-Ferrous-PVA hydrogel as a 3D dosimeter

Structural and optical studies of gamma-irradiated polyvinyl alcohol, polyethylene glycol, and lignosulfonate thin film

Preliminary Study of Normoxic PAGAT Polymer Gel Dosimeter by Adding Formaldehyde

Design and characteristics of an agar additive polymer gel dosimeter