Abstract:Background In carbon ion radiotherapy, accurate measurement of the three‐dimensional (3D) absorbed dose distribution is critical for effectively targeting tumors. Although micellar gel dosimeters exhibit considerable potential for measuring 3D absorbed dose distributions, few studies have focused on radiotherapy using carbon ion beams. Purpose This study investigated the applicability of the surfactant hydrogel dosimeter (SHD), a micellar gel dosimeter, to measuring a 3D dose absorbed through carbon ion beam irradiation. Methods A cubic target region of 34 mm per side was established at a depth of 46 mm below the upper surface of an SHD specimen. Scanning irradiation was performed using a pencil beam of carbon ions at the Ion‐beam Radiation Oncology Center in Kanagawa ("i‐ROCK"), Japan, under irradiation conditions set by the treatment planning system ("Monaco for Carbon", Ver. 5.20, Elekta AB, Sweden) to create a spread‐out Bragg peak within the target. The physical dose was set to 10 Gy at the isocenter, situated at the center of the target. The SHD responsiveness was measured twice using optical computed tomography (CT) ("Vista 15", Modus Medical Devices, Canada) for three irradiated specimens, and six types of measured optical attenuation coefficient (OAC) were obtained. To assess whether the OAC represented the absorbed dose expected in the treatment plan, we compared the relative distribution of the OAC and that of the absorbed dose. Relative fraction (RF) was used to measure the difference between the relative value of the OAC and that of the absorbed dose. Moreover, the distribution of OH radical (•OH) concentration obtained by Monte Carlo simulation ("PHITS" ver. 3.24 JAEA, Japan) and that of the OAC were compared. Results In the direction of beam travel, the relative distribution of the OAC was lower than that of the absorbed dose. This discrepancy could be attributed to a decrease in the concentration of •OH produced by irradiation owing to the recombination reaction, which does not accurately reflect the absorbed dose. By contrast, the distributions in the plane perpendicular to the beam travel were consistent. The RF increased from ± 3% to ± 13% along the beam travel direction. The small RF in the plane perpendicular to the beam travel could be attributed to the constant distribution of linear energy transfer, regardless of the irradiation position, and the generation of radicals proportionally to the absorbed dose. The increase in RF along the beam travel direction was ascribed to ring artifacts in the irradiated region. Conclusion The measurement of the absorbed dose distribution in the beam travel direction should be improved. The observed discrepancy is attributed to the reduced reactivity of the SHD due to a high liner energy transfer near the Bragg peak. However, the absorbed dose distribution can be effectively evaluated in the plane perpendicular to the direction of beam travel.

Radiation‐sensitive nanogel‐incorporated Fricke hydrogel dosimeters with reduced diffusion rates

Low-Diffusion Fricke Gel Dosimeters with Core-Shell Structure Based on Spatial Confinement

Development and characterization of a Fricke gel dosimeter for precise measurement in low-dose photon fields

Rare-earth doped radioluminescent hydrogel as a potential phantom material for 3D gel dosimeter

High-resolution 3D Radiochromic Hydrogel Photonic Crystal Dosimeter for Clinical Radiotherapy

Optical characterization of Fricke-methylthymol blue hydrogel dosimeter with gellan gum as physical cross-linker

Time-resolved observation of DHR123 nano-clay radio-fluorogenic gel dosimeters by photoluminescence-detected pulse radiolysis

Characterization of ferrous-xylenol orange-polyvinyl alcohol gel for gamma dosimetry using spectroscopy

Preliminary dosimetric characterization of EDBreast gel

Deep learning approach for diffusion correction in Fricke hydrogel dosimeters

Dose Response and Stability of Silicone-Based Deformable Radiochromic Dosimeters (flexydos3d) Using Spectrophotometer and Flatbed Scanner

Toward “on-line” X-ray computed tomography-based dosimetry using a new polymer gel with rapid response

Basic Properties of a New Polymer Gel for 3D-Dosimetry at High Dose-Rates Typical for FFF Irradiation Based on Dithiothreitol and Methacrylic Acid (MAGADIT): Sensitivity, Range, Reproducibility, Accuracy, Dose Rate Effect and Impact of Oxygen Scavenger

Feasibility of new polymeric matrices in the production of ferrous sulphate dosimeters

Magnetic Resonance Imaging Stud of New PAGAT Polymer Gel Dosimeter

CCD imaging for optical tomography of gel radiation dosimeters

On the Use of the Fricke-Pluronic F-127 Gel Dosimeter for Radiation Isocenter Testing of a Medical Linear Accelerator

Preparation and characterization of novel Sulfosalicylic acid-Ferrous-PVA hydrogel as a 3D dosimeter

Impact of Salt on Thermal Stability and Dose Response of the Fricke-XO-Pluronic F-127 3D Radiotherapy Dosimeter

A Preliminary Investigation of Radiation-Sensitive Ultrasound Contrast Agents for Photon Dosimetry

Three‐dimensional radiation dosimetry of carbon ion beams using surfactant hydrogels: Fundamental investigation