Abstract:The rock will be damaged and destroyed when the external load reaches the bearing limit, which will be accompanied by complex AE signals and damage evolution laws. Therefore, in order to obtain the relationship between AE signal and damage evolution characteristics of rocks, 4 kinds of sandstones of a mine are used for AE test. Firstly, the porosity of 4 kinds of sandstone is tested. Secondly, the AE signal parameter characteristics of sandstone with different porosity are analyzed. Finally, the AE parameters obtained are combined with cellular automata and damage theory to analyze the damage evolution law and critical damage value of different sandstones. The results show that the pore size of the four sandstones is QSYX > QSYZ > FSYX > FSYZ. The loading process is divided into compaction stage, elastic deformation stage, and plastic deformation stage, with peak strengths of 46.92 MPa, 43.32 MPa, 57.87 MPa, and 54.31 MPa, respectively. Or the AE event rate, the missing area, missing parts and missing number are different. The QSYX missing area is larger than QSYZ and FSYZ; the macrocrack growth speed is also faster; and the signs of fracture are obvious. The number of FSYX missing is more than QSYX, QSYZ, and FSYZ. The first two missing parts are caused by internal defects; the last two missing parts are signs of fracture; QSYX, QSYZ, and FSYZ are shear failure, and FSYX is tensile failure. The damage evolution process of the four sandstones corresponds to the loading process one by one. The calm stage of damage corresponds to the compaction stage, the damage expansion stage corresponds to the elastic deformation stage, and the damage acceleration stage corresponds to the plastic deformation stage. The critical damage values are 0.438, 0.499, 0.576, and 0.476, respectively, which are higher than the critical damage values of the sandstone cell model of 0.43, indicating that when the damage values reach the critical value, instability exists and instability failure will occur with continuous load.
What problem does this paper attempt to address?
The problem that this paper attempts to solve is: **Explore the acoustic emission characteristics and damage evolution laws of sandstones with different porosities under external loads**. Specifically, the researchers analyzed the characteristics of acoustic emission signal parameters of sandstone samples with four different porosities during the loading process through experiments, and combined with the cellular automata theory and damage theory, discussed the damage evolution laws and critical damage values of these sandstones.
### Detailed Interpretation:
1. **Background and Problem Statement**:
- When the external load reaches the bearing limit of the rock, the rock will be damaged and destroyed, accompanied by complex acoustic emission (AE) signals.
- The researchers hope to reveal the relationship between AE signals and damage evolution of sandstones with different porosities under external loads through experimental and theoretical analysis.
2. **Research Methods**:
- **Sample Preparation**: Four sandstone samples with different porosities were selected, namely QSY X, QSY Z, FSY X, and FSY Z.
- **Experimental Equipment and Parameter Settings**: The Newmai Minim - 60 MRI scanner and electro - hydraulic servo rock testing machine were used for porosity detection and uniaxial compression acoustic emission experiments.
- **Experimental Steps**:
1. After the different sandstone samples were saturated with water absorption treatment, they were placed in the sample detection device to receive signals and draw T2 spectra.
2. A uniform coupling agent was smeared on both ends of the specimen, the acoustic emission probe was fixed, and the testing machine parameters (pre - load of 2 kN, loading rate of 0.1 mm/min) and acoustic emission parameters (sampling frequency of 100 kHz, sampling length of 2048, waveform threshold of 40 dB, parameter threshold of 40 dB, amplifier gain of 40 dB) were set.
3. The testing machine and the acoustic emission system were run synchronously until the sample was broken, and the data was extracted and saved.
3. **Main Results and Conclusions**:
- **Porosity Distribution**: Through NMR detection, the T2 spectra of different sandstone samples were obtained. It was found that QSY X, FSY X, and FSY Z had both large and small pores simultaneously, while QSY Z was mainly composed of large pores.
- **Stress - Time Analysis**: The axial stress of the four types of sandstones was negatively correlated with the porosity, that is, the larger the pore, the smaller the axial stress. The stress - time curve can be divided into three stages: the compaction stage, the elastic deformation stage, and the plastic deformation stage.
- **Analysis of Acoustic Emission Event Rate and Cumulative Event Number**: The AE event rate showed a "rise - fall - rise - fall" trend with the change of axial stress, and the cumulative event number increased linearly. The AE event rates of sandstones with different porosities showed different change characteristics in each stage.
- **Analysis of Main Frequency Characteristics**: The AE main - frequency signals were mainly concentrated in the low - frequency and high - frequency regions, and there were fewer intermediate - frequency signals. According to the literature, the low - frequency corresponds to the initiation of micro - cracks, and the high - frequency corresponds to the generation of large cracks.
- **Analysis of Morphological Deterioration Characteristics**: The internal crack propagation types were characterized by RA - AF values. It was found that QSY X, QSY Z, and FSY Z were mainly shear failures, while FSY X was a tensile failure.
4. **Innovative Points**:
- Combined with the cellular automata theory and damage theory, the damage evolution laws and critical damage values of sandstones with different porosities were analyzed.
- Detailed experimental data and theoretical analysis were provided, which laid a foundation for further research on engineering rock stability.
### Summary:
This research revealed the acoustic emission characteristics and damage evolution laws of sandstones with different porosities under external loads through experimental and theoretical analysis, providing an important basis for understanding the rock fracture mechanism.