Abstract:A novel Rayleigh Doppler lidar technology based on a quadruple dual-pass Fabry–Perot interferometer (FPI) that can accurately measure wind field, temperature and aerosol backscatter ratio from the troposphere to lower stratosphere is proposed. This study aims to analyse the detection principle of wind speed, temperature and aerosol backscatter ratio in detail and obtain their measurement error formulas. The structure of this type of lidar is studied and designed. The FPI consists of two edge channels FPI-1 and FPI-2, aerosol channel FPI-M and locking channel FPI-L. FPI-1, FPI-2 and FPI-M use a dual-pass optical path, whereas FPI-L uses a single-pass optical path. The parameters of FPI are optimised as follows: the free spectral spacing (FSR) is 12 GHz, the FWHM of FPI-1 and FPI-2 are both 2.2 GHz, the peak-to-peak interval of FPI-1 and FPI-2 is 5.8 GHz, the FWHM of FPI-M and FPI-L are both 1.2 GHz, the peak-to-peak interval of FPI-M and FPI-1 is 2.9 GHz and the peak-to-peak interval of FPI-L and FPI-1 is 2.3 GHz. Under simulated atmospheric conditions, for a daytime sky background brightness of 0.3 Wsr −1 m −2 nm −1 at 355 nm, using a laser with a pulse energy of 350 mJ and a repetition frequency of 50 Hz and a telescope with a 0.45-m aperture, with a vertical range resolution of 30 m at 0–10 km, 100 m at 10–20 km and 500 m at 20–35km, temporal resolution of 30 min, zenith angle of 0° for temperature and aerosol backscatter ratio detection and temporal resolution of 3 min and zenith angle of 30° for radial wind speed detection, the detection performance of the designed Rayleigh Doppler lidar is determined. The simulation results show that the measurement errors of aerosol backscatter ratio, temperature and radial wind speed of the lidar system in the daytime and night-time are less than 4.36 × 10 −3 and 3.32 × 10 −3 (excluding cirrus cloud area), 4.0 K and 3.0 K and 3.8 m/s and 1.9 m/s, respectively, from an altitude of 0.06 to 35km.

A Three‐Frequency Ca+ Doppler Lidar for Ion Temperature Measurements in the E and F Regions

Observation of E × B Flow Velocity Profile Change Using Doppler Reflectometry in HL-2A

Design of a Three-Frequency Rayleigh Lidar for Simultaneous Temperature and Wind Measurements

Fiducial system for the diagnosis of temporal evolution of radiation fluxes with soft-X-ray spectrometer in inertial confinement fusion experiments

Simulation of wind-temperature-density measurement in near space by spaceborne Fe resonance fluorescence Doppler lidar

Design of a Data Acquisition, Correction and Retrieval of Na Doppler Lidar for Diurnal Measurement of Temperature and Wind in the Mesosphere and Lower Thermosphere Region

Narrowband Sodium Lidar for the Measurements of Mesopause Region Temperature and Wind

High Resolution 3-D Imaging of Mesospheric Sodium (Na) Layer Utilizing a Novel Multilayer ICCD Imager and a Na Lidar

Mobile Rayleigh Doppler lidar for wind and temperature measurements in the stratosphere and lower mesosphere

A new Lidar technology using frequency comb light source

Pseudorandom Modulation Continuous-Wave Narrowband Sodium Temperature and Wind Lidar

60 Km Rayleigh Doppler Lidar and Wind Measurement

Z-dependent Spatial Behavior of 4D-3P and 4F-3D Transitions of Li-like Ions in Laser-Produced Plasmas and the Electron Density Measurement

Optimization of scanning Fabry–Perot interferometer in the high spectral resolution lidar for stratospheric temperature detection

Rayleigh Doppler Lidar Technology Based on a Quadruple Dual-pass Fabry–Perot Interferometer

Laser Feedback Frequency-Modulated Continuous-Wave LiDAR and 3-D Imaging.

Scanning F-P Etalon Based High Spectral Resolution Lidar for Low-Stratosphere Temperature Measurement

Boundary layer ozone differential-absorption lidar

Measurements of Cirrus Clouds with a Three-Wavelength Lidar

Wind Profiling from High Troposphere to Low Stratosphere Using a Scanning Rayleigh Doppler Lidar

Lidar Technology Based on Fiber System and its Application