Abstract:Atmospheric constituents feature a large vertical gradient in concentration, especially at the first few hundred meters over the earth's surface. Atmospheric lidar usually cannot cover this range due to the incomplete overlap effect or the limited dynamic range of detectors. This drawback is well known as the blind zone effect, which hinders the application of atmospheric lidars in many aspects. In this work, a method based on an optical fiber bundle was proposed to mitigate the blind zone effect. An optical fiber head with several stages, installed at the focal plane of the telescope, is used to receive backscatter light from different range levels. The design of the optical fiber head is analyzed with the ray-tracing technique. The optical fiber installed at the highest stage of the fiber head can collect far-range light like a small aperture, and all the other optical fibers are bundled into a near-range detection channel to receive backscatter light from the first few hundred meters. This special design can avoid the near-range light loss in conventional lidar systems, usually equipped with a small aperture. Different optical attenuations are then applied to near-range and far-range channels to suppress the overall signal dynamic range. This light-receiving method was applied in a 1030 nm elastic lidar, in which a fiber bundle with a three-stage fiber head was fabricated and installed. A test experiment was performed to verify this approach. A good agreement between simulations and in-system results was found. Based on this design, the blind zone of the lidar system is less than 50 m, and the detectable range can be over 10 km along the lidar's line of sight with a single telescope receiver. This approach brings a new way of designing atmospheric lidar with a low blind zone and can strengthen our ability to monitor urban pollution and promote land-atmosphere interaction research.

Lidar Technology Based on Fiber System and its Application

Multi-Longitudinal-Mode High-Spectral-Resolution Lidar

Generalized High-Spectral-resolution Lidar Technique with a Multimode Laser for Aerosol Remote Sensing.

High-spectral-resolution Lidar for Ocean Ecosystem Studies

Solid-state 589 nm seed laser based on Raman fiber amplifier for sodium wind/temperature lidar in Tibet, China

Development of A Field-Widened Michelson Spectroscopic Filter for A Polarized Near-Infrared High Spectral Resolution Lidar

Polarized High-Spectral-Resolution Lidar Based on Field-Widened Michelson Interferometer

Design of a Data Acquisition, Correction and Retrieval of Na Doppler Lidar for Diurnal Measurement of Temperature and Wind in the Mesosphere and Lower Thermosphere Region

High-spectral-resolution Lidar for Ocean Biological Carbon Pump Studies

Development of the Zju Polarized Near-Infrared High Spectral Resolution Lidar

Lidar Network for Temperature and Wind Measurements in the Mesosphere and Lower Thermosphere Region

Pseudo-random modulation continuous-wave lidar for the measurements of mesopause region sodium density

Low Blind Zone Atmospheric Lidar Based on Fiber Bundle Receiving

Design of a High-Spectral-resolution Lidar for Atmospheric Temperature Measurement Down to the Near Ground.

Lateral scanning Raman scattering lidar for accurate measurement of atmospheric temperature and water vapor from ground to height of interest

Compact and lightweight 1.5 μ m lidar with a multi-mode fiber coupling free-running InGaAs/InP single-photon detector

A new Lidar technology using frequency comb light source

Compact And Lightweight 1.5 Mu M Lidar With A Multi-Mode Fiber Coupling Free-Running Ingaas/Inp Single-Photon Detector

Compact and lightweight 1.5 μm lidar with a multi-mode fiber coupling free-running InGaAs/InP single-photon detector

High Resolution 3-D Imaging of Mesospheric Sodium (Na) Layer Utilizing a Novel Multilayer ICCD Imager and a Na Lidar

Design of data acquisition system for distributed optical fiber sensor